毕业论文：基于单片机的步进电机控制设计.docVIP

邵阳学院毕业设计（论文） PAGE 46 毕业设计(论文) 课 题 名 称 基于单片机的步进电机控制设计 学 生 姓 名 学 号 系、年级专业 信息工程系﹑电子信息工程专业 指 导 教 师 职 称 讲 师 2009年 5 月 22 日摘 要 本论文主要介绍了基于单片机的步进电机控制的规则、硬件结构、软件代码的编写及工作原理、以及液晶模块12864LCD的详细介绍以及指令集。模拟出单片机系统下的步进电机转速控制，具有任意转速选择、转动时间、正反转、加速和减速设置、系统低功耗、可实现在线调试等特点。本系统是以单片机为其控制核心，以有源晶振构成的电路作为时钟信号，通过键盘输入选择向单片机控制系统发出步进转动控制命令，控制系统接收命令后做出一系列必要的判断后，控电机的转速、转向等。本设计已通过了实验仿真，运行稳定，达到了基本的设计要求。 本设计要分为两大块：一块为硬件电路组成部分，一块为软件程序设计部分。在硬件电路里主要包括有源晶振部分、键盘输入控制部分、电机驱动电路及液晶显示部分等与单片机的接线设计；软件编程方面主要是子程序和主程序的编写，包括：初始化代码、液晶驱动代码、时间记录代码、表格数据代码等。 关键词：单片机；步进电机；12864LCD；指令集 Abstract This thesis is mainly introduce the Prepared and working principles about regulation、structure of hardware、software code of stepping motor control based on MCU as well as detail information and instruction set on LCD Module 12864LCD. This thesis also simulates that under the system of single-chip stepping motor speed control has the disadvantages of changing speed、time arbitrary、Positive and negative transfer、installation of accelerated and deceleration、low-power system and online debugging. Single-chip as core of control and the circuit made up by active crystal as clock signal, the stepper motor speed control system starts to making a series of necessary judgment and then control rotate speed and change direction when it receive the command of stepper transfer control from single-chip control system by keyboard. As run steady, this project has already passed the simulation and has achieved the basic purpose. This project consists of two parties. One is hardware circuit and the other is software programming. In the part of hardware circuit is include active crystal、control system of keyboard input 、system of motor drive circuit and liquid crystal system. In the second part, D