毕业设计（论文）--基于89S52单片机微型打印机控制电路的设计.doc

毕 业 设 计（论文） 题 目 微型打印机控制电路的设计 副标题 性 质： 毕业设计 毕业论文 学生姓名 班 级 系 别 专 业 指导教师 评定成绩 优 良 中 及格 不及格 微型打印机控制电路的设计 摘要TPμP-40A微型打印机，采用89S52单片机控制利用并行接口技术通过液晶显示的等特点control circuit in Micro-printer Abstract：Nowadays, electronic field is developing towards the direction of digitization、informatization and micromation. As one of data output equipments, the printer is also spreading out in multifunction、high-performance. And the Micro-printer is a very important output equipment in electronic information field. Based on Micro-printer——TPμP-40A, this design adopts micro-controller (89S52), makes use of parallel-interface technique and in the meantime displays printing data and word information on Liquid Crystal Display. It can print a paragraph of regular Chinese characters and single discretional number. At the same time the Liquid Crystal Display can display print content. It possesses the characteristics of high-speed、low-noise、small-volume 、lightweight、reliable running and low cost of maintenance. Keywords: Micro-printer Single Chip Computer Liquid Crystal Display Keyboard 目 录 1 引言…………………………………………………………………………………1 2 设计要求……………………………………………………………………………1 3 系统组成……………………………………………………………………………1 4 硬件部分设计………………………………………………………………………2 4.1打印机部分………………………………………………………………………2 4.2单片机芯片部分………………………………………………………………5 4.3 单片机与微型打印机的接口……………………………………………………7 4.4单片机与液晶显示器的接口……………………………………………………11 4.5键盘部分…………………………………………………………………………15 4.6 电源模块设计……………………………………………………………………18 5 软件部分……………………………………………………………………………20 5.1 程序设计整体流程图……………………………………………………………20 5.2 键处理流程图…………………………………………………………………21 6 显示与测试结果……………………………………………………………………22 7 结论…………………………………………………………………………………23 参考文献………………………………………………………………………………24 致谢……………………………………………………………………………………25 附录 1：程序…………………………………………………………………………26 附录2：整机电路图…………………………………………………………………47 英文资料及中文翻译……………………………