F1891881汽车产品要求.docVIP

Requirements Specification for Automotive Flat Cable Contact Systems Revision 4.0 History Rev. Section Modification Date Name 1.0 All New 14.11.2007 HAD Team 2.0 As listed - Figure 3 removedRecommendation for rigid materials- Figure 13 added Skewed insert angel - Vibration test revised - Preconditioning 240°C peak - Damp heat steady state Alternative 1 +40°C/95%rH 2500h Alternative 2 +55°C/95%rH 1300h Alternative 3 +65°C/95%rH 900h - Rapid change of temperature +115°C 07.08.2009 HAD Team 3.0 All Transition from HBS to Form F1891881, Rename HBAS to HAD 2010-12-22 M.Wicker Content 1 Preface 5 2 Purpose 5 2.1 Objectives 5 2.2 Scopes 6 3 Validity 6 4 Terms and Definitions 7 5 Referenced Documents 7 6 General Requirements 9 6.1 Description of the system 9 6.2 Definition of family 11 6.3 Test board for qualification 12 6.4 Requirements 13 6.4.1 Connection System 13 6.4.2 Connectors 13 Process requirements and solder ability 13 Mechanical requirements 14 6.4.3 Flat cables (FFC / FPC) 14 6.5 Responsibilities 14 7 Release process 15 7.1 Milestones 15 7.2 Documentation 15 7.2.1 System 15 7.2.2 New variants of connectors 15 7.2.3 New variants of flat cable 15 7.3 Requalification / Monitoring 16 7.4 Changes 16 7.5 Archiving / Retained samples 16 8 Qualification 17 8.1 General Requirements 17 8.1.1 Target of the qualification 17 8.1.2 Required measurement equipment: 17 8.2 Documentation / Acceptance criteria 18 8.3 Qualification plan 18 8.3.1 Supplier information / qualification single component 19 Sample Inspection Report 20 Peel test 20 Contact dimension 21 Contact construction 22 Performance single components 22 Bending 24 Folding 26 Flame resistance 26 Abrasion 26 8.3.2 Design verification 27 Pin matching between Connector and Flex (Pitch tolerance) 28 Metallurgic analyses of the contact pins flex and connector 28 8.3.3 Mechanical tests 29 Insertion Behavior 30 Mating Cycle 30 Vibration test 31 Retention Force 32 8.3.4 Electrical tests 34 Co