数控直流电流源研究设计与应用报告.docVIP

数控直流电流源(F题)设计与总结报告 摘 要 本设计以89C51单片机为控制器 ，以温度系数小、精度高的锰铜丝作为电流取样电阻，并采用AD公司的12位D/A转换器（AD667芯片）来产生电流源所需的输入电压。电路主要由控制、显示电路、电流源电路以及电源电路几部分构成。 由于在电流源电路中采用锰铜丝作为电流取样电阻，同时使用大功率复合管作为调整管，不仅使电流源的精度达到给定的要求，同时输出电流的量程还可以进一步提高。另外，在电路设计时，将负载接地，并采用从取样电阻两端取控制信号，不仅保证了电流的转换精度，同时可以实现电流0~2000mA调整范围。 关键词： 高精度　　大电流　　数控　　直流电流源 精密锰铜丝电阻 Abstract This design take of 89C51 as the core, using the temperature coefficient manganese copper wire electric resistance of high stability to carry on the sample and examinations to the electric current, the number that makes use of the basis electric voltage of 12 D/A conversion machine( chip of AD667) creation nicety that the American AD company produce to carry out controls the direct current eternaly to flow the source.Electric circuit from control manifestation flow the source two greatest parts composing with the direct current eternally .he control shows the mold piece from a machine, the several parts such as the D/ A conversion electric circuit, keyboard and the manifestation electric circuit etc. constitute.The direct current eternally flows the source under the function that control the part, produce a stable electric current, make use of the nicety sample electric resistance to carry on the sample to that electric current, the electric voltage that get is the feedback in accordance with the controller the output and high accuracy th e reference the electric voltage carry on the comparison, and the error margin electric voltage enlarge the empress the control the adjustment the tube, make the electric current of the sample the value and the pre-established electric current the value incline to, attain the nicety number to control the direct current eternally to flow the source purpose finally.Because the eternally flow the source is to use a pair of controls systemses, make the eternally flow the electric current of the source to output the scope and can attain 0-2000 milli- Anne, not only good satisfied the topic 20-2000 mill