大淑村矿1.2Mta新井设计.doc

摘 要 本设计包括三部分：一般部分，专题部分，翻译部分。 一般部分为峰峰集团大淑村矿1.2Mt/a新井设计，共分十章：矿井概述及井田地质特征，井田境界和储量，矿井工作制度、设计生产能力及服务年限，井田开拓，准备方式—采区巷道布置，采煤方法，井下运输，矿井提升，矿井通风及矿井基本技术经济指标。 大淑村矿区位于距离邯郸市区北约40千米，矿区对外交通便利。区内地势较为平坦，井田走向长度7.2千米，倾斜方向长3.8千米。面积为14.5平方千米。井田可采煤层为2#。厚度分别为8.5米，煤层倾角平均为11度。井田可采储量为8862.0971万吨，新井设计生产能力为120万吨/年，服务年限为52年。 大淑村煤矿矿井工作制度为“三八”制，一个工作面保产。开拓方式为立井单水平开拓，水平标高为-305。矿井主井采用箕斗提煤，副井采用罐笼作为辅助提升。工作面采用走向长壁采煤法，采用集中布置，工作面长180米，采煤工艺为轻放。运输大巷采用胶带运煤，大巷辅助运输采用电机车运输材料和矸石。矿井采用中央并列式通风，主扇工作方式为抽出式。 专题部分主要介绍的是松软顶板巷道支护技术 翻译部分对中国城乡家庭能源消费结构变化的描述和介绍。 关键词：井田 ；煤矿 ；开拓 ；采煤 Abstract This design contains three parts: the general part, the special part and the translated part. The general part is a new design of ShuEr mine belongs to FengFeng mining bureau whose production capacity is 1200 kt per year .It has ten chapters as follows: the outline of mine and mine field geology, boundary and reserves, working system and productive capacity and service life, development method of the mine, the main roadways, coal mining method and layout or roadways in working area, transportation of underground, mine lifting, mine ventilation and safety, main technique—economic induces. The ShuEr mine filed lies in the north of HanDan about 40 kilometers .The transportation is convenient and the geological condition is simply .It covers 14.5 square kilometers. The boundary of the minefield run 7.2 kilometers on the strike and the pitch length is 3.8 kilometers. The two layers of seams are 2# and 4# coal. The thickness of 2# coal is 8.5 meters; The average angle of the coal seams is 11 degrees. The accessible reserves of the minefield are 88.6209Mt.The design production capacity is 1200 kt per year. The service life is 52 years. The working system is “3--8”. one productive places meet the requirement. The mode of development about the mine is shaft development. The mine has one levels, the level locates in the level of –450meters..The main shaft uses skip hoisting and the auxiliary shaft adopts cage hoisting. The working face adopts l