基于PLC的皮带监控系统毕业设计.docVIP

存档日期： 存档编号： 江 苏 师 范 大 学 本科生毕业论文（设计） 论 文 题 目： 基于PLC的皮带监控系统 姓 名： 张帅 院 系： 电气工程及自动化 专 业： 自动化 班 级： 10电51 指 导 教 师： 张兴奎 江苏师范大学教务处印 摘要 皮带输煤系统是工矿企业中一个常见并且是比较大型的公用系统。目前,许多企业经过传送带来完成物料的运送的。一个完整的输煤系统的组成部分主要有较长的传送带和电机。为了确保煤矿输送系统的稳定与可靠的运行，为了提高煤矿自动化水平，因此研究带式输送机的自动控制是很有意义的。 本系统在剖析了带式输送机集中控制系统功能基础之上，以FX2n系列PLC为控制核心构造了4条皮带自动控制系统。该系统由操作控制页面和PLC组成，操作控制页面主要用来实时显示带式输送机系统的运行状态，并且可以进行远程控制。PLC主要作用是进行现场信号采集，将采集到的信号传输给上位机，并且根据采集到的信号进行现场处理。 在本系统设计中，我先详细介绍了带式输送机系统的组成，并剖析了带式输送机常见故障及保护措施，然后进行了各控制器的选型。本文主要以单台PLC控制为例，详细说明单台PLC控制过程，然后介绍了PLC之间的通信，并且以组态作为人机界面进行人机沟通，最后对本系统进行软件设计。 关键词：煤矿 皮带 控制 PLC 组态 Abstract Belt conveying system is a common in industrial and mining enterprises and is relatively large utility system. The majority of enterprises in the present stage, they are done through belt conveyer conveying process. A complete part of the main coal conveying system has many sets of conveyor belt conveyor with long distance. In order to ensure the safety of the underground coal mine transport system, efficient, reliable operation, in order to improve the automation level in coal mine, so the automatic control of belt conveyor is very meaningful. This system in the analysis of the belt conveyor based on centralized control system function, with the FX2n series PLC as the core four belt automatic control system is constructed. The system is composed of operation and PLC control sheet, operating control page is mainly used to real-time display of the operation of the belt conveyor systems, and can be remotely controlled. PLC main function is to conduct on-site signal acquisition, the collected signal transmission to the PC, and according to the collected signal processing at the scene. In the system design, I first introduced the composition of belt conveyor system, and analyzes the common failures