建新煤矿0.9Mta新井设计（含CAD图纸全套）.doc

买文档后送图纸，QQ 194535455 摘 要 毕业设计包括三个部分：一般部分、专题部分和翻译部分。 一般部分为丰城（集团）建新矿0.9Mt新井设计。该煤矿位于江西省丰城市东南面，交通便利。井田走向（东西）长约3.5公里，倾向（南北）长约4.0公里，面积约14平方公里。主采煤层为4号煤，平均倾角为9°，煤层平均总厚为3.5m。井田地质条件较为简单。 井田工业储量为77.5Mt，矿井可采储量56.1Mt。矿井服务年限为47a，涌水量不大，矿井正常涌水量为25-35m3/h，最大涌水量为107m3/h。矿井瓦斯相对涌出量45.7 m3/t m3/t，为高瓦斯矿井。 井田为立井二水平开拓。大巷采用胶带运输机运煤，辅助运输采用无极绳连续运输，矿井通风方式为前期中央并列式通风，后期中央分列式通风。 矿井年工作日为330d，工作制度为“三八”制。 一般部分共包括10章：1.矿区概述及井田地质特征；2.井田境界和储量；3.矿井工作制度及设计生产能力、服务年限；4.井田开拓；5.准备方式-带区巷道布置；6.采煤方法；7.井下运输；8.矿井提升；9.矿井通风与安全技术；10.矿井基本技术经济指标。 专题部分题目: 综放工作面瓦斯抽采技术分析 翻译部分主要内容: 综放沿空掘巷卸压技术研究 英文题目为: Study on destressing technology for a roadway driven along goaf In a fully mechanized top-caving face 关键词：工业储量 ；立井开拓 ；工作制度 ；采煤方法 ；矿井通风  Abstract: The design is made of three parts: general part, special part, and translation. The general part is the design of a new mine with a volume of 0.9mt in Jianxin Minging CO;Ltd.in Fengcheng. Jianxin Minging CO;Ltd. locates in the southeast of Fengcheng. The traffic there is very convenient. The minefield is about 3.5kms long(from east to west) and about 4.0kms wide(from north to south), with an area of 12 square kms.The main exploited coal bed is NO.4, which has an average dip of 9’. The average thickness of the coal bed is 3.5m. so, it’s clear that the geological terms are very simple there. The industrial reserves of the mine are 77.5mt, the exploitative reserves of the mine are 56.1mt. the service period of the mine are 58a. The gushing capacity of the mine is not very huge, with a normal volume of 25-35m3/h and a maximum volume of 107m3/h. the mine, with a relative volume of 45.7m3/t gas gushing out,can be named high-gas mine. vehicles with fixed trunk weighing 1.5t can be adopted in big tunnels, and also be used as supplementary haulage. The pattern of ventilating is center-boundary ventilation. The mine is estimated to work 330days in a year, with “8hours, 3shifts”working regulation. There are ten chapters in the general part. Chapter one：introduction of mine area and geolog