KeyInjectionProtocolGuideV1.0(2014-10-11)教程.doc

Blue Bamboo Key Injection Protocol Guide Products: H50 Advantage Firmware: Build 70 or higher Document version: 1.0 Document date: 2012-10-11 BLUE BAMBOO Headquarters Blue Bamboo Transaction Systems (Shanghai) Co., Ltd. 6 Floor, Huishan Technology Park, No. 3333 Changning Road,Shanghai, P.R. China 200336Tel: +86 21 5219 0333Fax:+86 21 5219 0603 Copyright ? 2012 BLUE BAMBOO All rights reserved. No part of this publication may be copied, distributed, stored in a retrieval system, translated into any human or computer language, transmitted, in any form or by any means, without the prior written consent of BLUE BAMBOO. All other brand names and trademarks in this guide are the property of Blue Bamboo. Information in this document is subject to change without notice.Contents Introduction 2 1 User Interface of Key Injection 2 1.1 Set baud rate 2 1.1.1 Display Current Baud Rate 2 1.1.2 Provide a List of Baud Rate 2 1.2 Inject key 3 1.2.1 Waiting for Key Injection 3 1.2.2 Display Key Type and Result 3 1.2.3 Exit Key Injection 3 2 Communication protocol 4 2.1 Procedure 4 2.2 Data Frame 5 2.3 Key injection commands 7 2.3.1 MK/SK Key Injection Request 7 2.3.2 MK/SK Key Injection Response 7 2.4 Injection example 8 3 Version History 10  Introduction This document will introduce you to inject MS/SK key and Fixed key on a Blue Bamboo H50 Advantage terminal. User Interface of Key Injection It will show four lines on the H50 Advantage terminal. This section will show the UI elements of user interface of key injection. The main steps are as following: Set baud rate Display current baud rate Provide a list of baud rate Inject key Display message that terminal is waiting for key injection Display key type and injection result Exit key injection and release the resource Set baud rate Display Current Baud Rate This step is used to display current baud rate of the terminal, the current baud rate will be highlighted. No. Line Alignment Display content 1 Middle Baud