2.aruba初始化配置.pptxVIP

初始化配置设置方法1方法1，以总线方式接入到内网（AP需要有外接供电电源或其他POE交换机供电）：步骤1：用串口线（与思科相同的串口线），连接SERIAL端口，登录“控制器”User: adminPassword: *****(Aruba200) (Aruba200) enablePassword:*****(Aruba200) #步骤2：清除旧有配置并重启(Aruba200) #write erase （注意：不要“write erase all”，这样会连License一起清除）All the configuration will be deleted. Press y to proceed :Write Erase successful?(Aruba200) #reloadDo you really want to reset the system(y/n): ySystem will now restart!Shutdown processing started步骤3：输入初始配置并重启Enter System name [Aruba200]: Enter VLAN 1 interface IP address [54]: 23（输入内网没用的IP，这里为假设）Enter VLAN 1 interface subnet mask []: Enter IP Default gateway [none]: Enter Switch Role, (master|local) [master]: 　（在只有一台控制器的情况下一般我们把主控制器设为主）Enter Country code (ISO-3166), ctrl-I for supported list: cn　（cn代表中国）You have chosen Country code CN for China (yes|no)?: yEnter Time Zone [PST-8:0]: Enter Time in GMT [02:31:57]: Enter Date (MM/DD/YYYY) [4/11/2007]: Enter Password for admin login (up to 32 chars): *****　（设置admin的密码）Re-type Password for admin login: *****Enter Password for enable mode (up to 15 chars): *****　（设置enable模式下的密码）Re-type Password for enable mode: *****Do you wish to shutdown all the ports (yes|no)? [no]: ?Current choices are:?System name: Aruba200VLAN 1 interface IP address: 23VLAN 1 interface subnet mask: IP Default gateway: noneSwitch Role: masterCountry code: cnTime Zone: PST-8:0Ports shutdown: no?If you accept the changes the switch will restart!Type ctrl-P to go back and change answer for any questionDo you wish to accept the changes (yes|no)y?System restarted!步骤4：将连接到ARUBA的所有无线用户初始权限设为“开放所有”　（注意：如果没有PEF模块，则不需要这步）(Aruba200) #configure tEnter Configuration commands, one per line. End with CNTL/Z?(Aruba200) (config) #aaa derivation-rules user　（进入设置用户初始网络权限）(Aruba200) (user-rule) #set role condition essid equals aruba-ap set-value pre-employee(Aruba200) #?现在，重新连接一次aruba-ap这个SSID（如果之前已连上，则断开再连接一次）这时，已经把无线用户接入到内网。?(Aruba200) #show user　（查看用户状态，用户已获取pre-employee这个最高的权限）Users IP MAC Name Ro