ASTM_B88-03无缝铜水管.pdfVIP

Designation: B 88 – 03 Standard Specification for Seamless Copper Water Tube1 This standard is issued under the fixed designation B 88; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon () indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. 1. Scope* 1.4 Solders for joining copper potable water or fire sprinkler 1.1 This specification covers seamless copper water tube systems are covered by Specification B 32. The requirements suitable for general plumbing, similar applications for the for acceptable fluxes for these systems are covered by Speci- conveyance of fluids, and commonly used with solder, flared, fication B 813. or compression-type fittings. The type of copper water tube 1.5 The following safety hazards caveat pertains only to the suitable for any particular application is determined by the test methods portion, Section 15, of this specification: This internal or external fluid pressure, by the installation and standard does not purport to address all of the safety concerns, service conditions, and by local requirements. Means of joining if any, associated with its use. It is the responsibility of the user or bending are also factors which affect the selection of the of this standard to establish appropriate safety and health type of tube to