GBT 6402-91标准（英文版）.pdfVIP

National standard of the Peoples Republic of China GB/T 6402-91 Replace: GB/T 6402-86 Steel Forgings - Method for Ultrasonic Examination Approved by the State Technical Supervision Bureau on Dec. 13, 1991 Implemented on Oct. 1, 1992 1. Subject Content and Application Scope The standard specifies the ultrasonic examination method of steel forging, reference block, inspection instrument and facility, examination condition and sensitivity adjustment, deficiency assessment, quality class and inspection report, etc. The standard is applicable to the general forging ultrasonic examination for carbon steel and low alloy steel with thickness or diameter more than 100mm with impulse reflection type ultrasonic process. 2. Normative References ZBY 230 A-type impulse reflection type ultrasonic flaw detector general technical specifications GB 9445 Qualification and certification of nondestructive testing personnel-general principles 3. General Requirements 3.1 The forging is tested by adopting ultrasonic longitudinal wave direct contact method or immersion method. For the annular or hollow forging with ratio of the outer diameter and inner diameter less than 1.4 and axial length exceeding 50mm, if necessary, the multiplicable ultrasonic transverse wave examination shall be noted in the specifications beforehand. 3.2 The forging ultrasonic examination staff shall be trained according to prescription in GB 9445 and obtained the qualification certificate. For the staff signed the inspection report, the staff shall obtain Class 11