安刻牌玻璃刻绘机USB控制卡使用说明及接口说明书(英文版).docVIP

Manual of Artcut Software Section 1 Equipment Connection Controller Connection Controllers fall into two types, namely Card A and Card B. They come with the same functions but differ in their way of connection. The following is the respective description of ways to connect the two types of cards: Connection for Card A: Connection for Card B: II. Connection of adapter Card A has to be connected via an adapter; as Card B comes with an adapter, there is no need for connecting adapter for it. The following is the description of adapter for Card A and relevant wiring: Connection of handheld keyboard: Fix the aviation socket onto the case and weld one end of the serial line with the aviation socket. The welding method is as follows: Pin of aviation socket 1 to be welded with black line (corresponding to DB9 Pin 1) Pin of aviation socket 2 to be welded with red line (corresponding to DB9 Pin 2)Pin of aviation socket 3 to be welded with green line (corresponding to DB9 Pin 3) Pin of aviation socket 4 to be welded with blue line (corresponding to DB9 Pin 5) Pin of aviation socket 5 to be welded with shielded line (corresponding to DB9 case) 2. Connection between adapter and master controller： Plug 40P cable to adapter (connected to point 29) and then plug the other end of the cable to the controller. 3. Description of definitions for adapter wiring: 1—Pulse signal on Axis X 2—Direction signal on Axis X 3—Pulse signal on Axis Y 4—Direction signal on Axis Y 5—Pulse signal on Axis Z 6—Direction signal on Axis Z 7—Pulse signal on Axis R 8—Direction signal on Axis R 9—5V earth output 10—5V power output 11—PWM output 1 12—PWM output 2 13—Laser switch signal 14—Main carving axis switch signal 15—Laser power control output 16—Main carving axis rotating speed control output 5V input status12V input status 17—5V or 12V earth wire input (Note: laser carver demands 5V power input while mechanical carver demands 12V power