3. 试验结果与分析 3. test results and analysis ayou翻译.doc

3. 试验结果与分析 3. test results and analysis ayou翻译 3. 1 缺陷信号 3.1 defect signal 腹板接头螺栓孔模拟缺陷信号如图 2 所示。 Web connector bolt hole defect analog signal as shown in Figure 2. 裂纹长度 Crack length 增大其涡流传感器的输出电压增加，在裂纹长度Increasing the eddy current sensor output voltage increases, the crack length L_，信号峰值出现凹陷，这是因为裂纹长度小于传感器线圈直径造成的。 , The signal peak sag, because the crack length is less than the diameter of the sensor coil caused. ，信号电压幅值已基本不再增加而趋于饱和，这是因为涡流效应区域小于裂纹长度。 , The signal voltage amplitude is saturated and no longer increases substantially, because the area is smaller than the eddy current effect of