R5R6中的Iur,Iu,Iub接口协议栈.docVIP

R5/R6中这些接口协议栈相对于R4/R99的区别在于，底层的承载除了ATM，还增加了IP的方式。 Iu Interface Protocol Structure 25.410 General The Radio Network signalling over Iu consists of the Radio Access Network Application Part (RANAP). The RANAP protocol consists of mechanisms to handle all procedures between the CN and UTRAN. It is also capable of conveying messages transparently between the CN and the UE without interpretation or processing by the UTRAN. Over the Iu interface the RANAP protocol is, e.g. used for: - Facilitate a set of general UTRAN procedures from the Core Network such as paging -notification as defined by the notification SAP in [3]. - Separate each User Equipment (UE) on the protocol level for mobile specific signalling management as defined by the dedicated SAP in [3]. - Transfer of transparent non-access signalling as defined in the dedicated SAP in [3]. - Request of various types of UTRAN Radio Access Bearers through the dedicated SAP in [3]. - Perform the SRNS Relocation function. The Radio Access Bearers are provided by the Access Stratum. Over Iu-BC, a datagram mechanism is used, so there is no clear separation of control and user planes, and the SABP protocol is used for data transfer and signalling. Iu-CS Figure 6.1 shows the protocol structure for Iu-CS, following the structure described in [1]. Figure 6.1: Iu –Interface Protocol Structure towards CS Domain Iu-BC Figure 6.2 shows the protocol structure for the Iu-BC. Figure 6.2: Iu Interface Protocol Structure towards Broadcast Domain Iu-PS Figure 6.3 shows the protocol structure for Iu-PS, following the structure described in [1]. Figure 6.3: Iu Interface Protocol Structure towards PS Domain Summary The present document, 3GPP TS 25.410, specifies the general aspects and principles of the Iu interface as a whole. The relationship between the other technical specifications that define the UTRAN Iu interface is shown in figure 7.1. Figure 7.1: Summary of Iu Interface Specification Structure Use of Transport Network User Pla