发电机启动停机检查.pptVIP

发电机的启动停机及检查 值班长接到值长启动的命令后，将发电机本体及辅助设备的一切工作票收回，拆除所有的安全措施，并安排值班员填写操作票。All work of the maintenance tickets is completed, dismantle all safety facilities, arrange the operator to fill the operation ticket. 发电机启动前的检查、测量工作：发电机本体及有关附属设备工作票全部收回，安全措施全部拆除，恢复常设标示牌和安全隔离措施，工作人员撤离现场、进行电气设备全面检查。Inspection and measurements before start: Take back generator and subsidiary equipments operation ticket,dismantle the safety precaution,recover the permanent board and security isolation measures,the workers leave site after check the electrical equipment. 电工检查Following inspection should be carried out （1）励磁机、发电机端部应清洁，电缆引出线及外壳接地线应牢固无损伤，各部完整，无影响机组启动的物体；Exciter and top of generator should be clean, there is no damage between outgoing cable and shell. （2）轴承下部油管法兰绝缘垫应无短路。大轴接地电刷接线牢固，压簧完整，接触应良好，活动自如There is no short circuit of flank insulation under the bearing. Earthing brush is fastened, proper connection and free moving. ； （3）发电机窥视孔应清洁无破损；Inspection hole is clean （4）发电机出、入口风温度计应完整，灭火装置应正常完好；Inlet and outlt thermometer is in good condition, fire extinguishing apparatus as well （5）发电机滑环清洁，励磁电刷dynamo brush在刷握内无卡住现象且完整，活动自如，长度不得短于25mm；Slip ring is clean, excitation brush is freely moving, the length is no less than 25mm （6）调速电机接线良好，正确牢固；Speed governing moter is in good connection （7）空气冷却器室清洁严密，无泄漏积水。Air cooler is tightness, and no leakage. Operator should carry out the following inspeciton主值班员应进行下列检查 检查保护屏各接线应牢固，端子排使用正确，控制开关把手及各转换开关使用正确，同期开关等均处于解除状态； Check the connection of protection pannel, control switch is in good position, sychronization switch is not connected. （2）检查控制屏、保护屏各熔断器应完整无损；check the fuse of control pannel and protection panel （3）发电机励磁调节屏检查，灭磁开关检查； Check regulation pannel of exciter and magnetic shut-down switch. 对发电机各保护装置检查，保护均应投入。Check the generator protector. 副值班员在值班电工的监护下进行下列测量 Deputy operator should carry out following measure under the monitor of electrician. （1）确认发电机开关、电压互感器隔离开关在断开位置，用2500V摇表测量定子回路绝缘电阻，其值不低于过去同温度下测量的1/3，而吸收比R60/R15≥1.3，最低值不低于10MΩ，如低于上述规定应报告值长并检查处理；Co