S3C2440 uboot2010.06 LCD驱动移植手册.pdfVIP

十四、添加LCD 驱动和LOGO 制作 1、在drivers/video 目录中新增s3c2440_fb.c ，代码如下： #include common.h #if defined(CONFIG_VIDEO_S3C2440) #include video_fb.h #include videomodes.h #include asm/arch/s3c24x0_cpu.h #include asm/io.h /* * Export Graphic Device */ GraphicDevice smi; #define VIDEO_MEM_SIZE 0x200000 #define MVAL (0) #define MVAL_USED (0) //0=each frame 1=rate by MVAL #define INVVDEN (1) //0=normal 1=inverted #define BSWP (0) //Byte swap control #define HWSWP (1) //Half word swap control #define VBPD (12) #define VFPD (4) #define VSPW (10) #define HBPD (43) #define HFPD (8) #define HSPW (1) #define CLKVAL_TFT (4) void lcd_enable(void) { struct s3c24x0_gpio * const gpio = s3c24x0_get_base_gpio(); struct s3c24x0_lcd * const lcd = s3c24x0_get_base_lcd(); gpio-GPGUP = gpio-GPGUP ((~(1 4)) | (1 4)); gpio-GPGCON = gpio-GPGCON ((~( 3 8)) | ( 3 8)); gpio-GPGDAT = gpio-GPGDAT | (1 4 ); lcd-LCDCON5 = lcd-LCDCON5 ((~( 1 3)) | (1 3)); // PWREN lcd-LCDCON5 = lcd-LCDCON5 ((~( 1 5)) | (0 5)); // INVPWREN lcd-LCDCON1 |= 1; gpio-GPBUP = gpio-GPBUP ((~(1 1)) |(1 1)); gpio-GPBCON = gpio-GPBCON ((~( 3 2)) |( 3 2)); gpio-GPBDAT = gpio-GPBDAT | (1 1 ); } /******************************************************************** *********** * * Init video chip with common Linux graphic modes (lilo) */ void *video_hw_init (void) { struct s3c24x0_lcd * const lcd = s3c24x0_get_base_lcd(); GraphicDevice *pGD = (GraphicDevice *)smi; int videomode; int bppmode; unsigned long t1, hsynch, vsynch; char *penv; int tmp, i, bits_per_pixel; struct ctfb_res_modes *res_mode; struct ctfb_res_modes var_mode; tmp = 0; videomode = CONFIG_SYS_DEFAULT_VIDEO_MODE; /* get video mode via environment */ if ((penv = getenv (vi