《skf轴承OK_1》.pdfVIP

OK shaft couplings Contents 3 The clever connection 4 The OK coupling explained 6 OKC 100 - 190 7 OKC 200 - 400 8 OKC 410 - 490 8 OKC 500 - 520 9 OKC 530 - 1000 10 OKF 100 - 300 11 OKF 310 - 700 12 OKCS 178 - 360 13 OKTC 245 - 790 14 Tailor-made OK couplings 15 Power transmission capacity 15 Safety factors 16 Shafts 16 Conversion tables 17 Hollow shafts for OKC 17 Hollow shafts for OKCS and OKF 18 Modular equipment for mounting and dismounting 20 Oil 20 Approved by leading classification societies 21 Locating device for outer sleeve 21 Mounting arrangements for OKC couplings 22 The Supergrip bolt cuts down on downtime The clever connection When using the OK couplings for shaft connec- tions, you take advantage of our powerful oil inj ection method. Preparation of the shaft is simple. No keyways to machine, no taper and no thrust ring. When mounting the OK coupling, a thin inner sleeve with a tapered outer diameter slides onto the shaft. A thick outer sleeve with a matching tapered inner surface fits onto the inner sleeve. Ordinary mineral oil is then inj ected between the sleeves. A built-in hydraulic jack drives the outer sleeve up the taper of the inner sleeve. When the outer sleeve has reached its final position an interference fit is created – j ust as if the outer sleeve had been heated and shrunk on. But no heat is required, and the coupling can be removed as easily as it was mounted. This powerful use of friction enables the OK coupling to transmit torque and axial loads over the entire area of the shaft. There are no stress raisers at the keyway. And no fretting when high shock or reversing loads exist. Make it the clever way ! Let the OK coupling work or y ou. You’ll save both time and money !