EIGRP手动汇总.docVIP

手动汇总特点： 1.减少路由条目。 2.减少正常数据的延时， 3.占用内存和CPU资源的减少。 4.减少带宽的占用。 拓扑如下： 将RouterA上的loopback0、1、2三个接口汇总成一条路由向RouterB宣告。 ? 步骤一：首先我在RouterA与RouterB之间做好基本配置并启用EIGRP发布网段 RouterA： Router Routeren Router#conf t Router(config)#hostname RouterA RouterA(config)#interface f0/0 RouterA(config-if)#ip address 192.168.1.1 255.255.255.0 RouterA(config-if)#no sh RouterA(config)#interface loopback 1 RouterA(config-if)#ip address 172.16.1.1 255.255.255.0 RouterA(config-if)#int lo2 RouterA(config-if)#ip address 172.16.2.1 255.255.255.0 RouterA(config-if)#int lo3 RouterA(config-if)#ip address 172.16.3.1 255.255.255.0 RouterA(config-if)#exit RouterA(config)#router eigrp 1 RouterA(config-router)#no auto-summary RouterA(config-router)#network 192.168.1.0 0.0.0.255 RouterA(config-router)#network 172.16.1.0 0.0.0.255 RouterA(config-router)#network 172.16.2.0 0.0.0.255 RouterA(config-router)#network 172.16.3.0 0.0.0.255 RouterA(config-router)#end RouterA# RouterB： Router Routeren Router#conf t Router(config)#hostname RouterB RouterB(config)#interface f0/0 RouterB(config-if)#ip address 192.168.1.2 255.255.255.0 RouterB(config-if)#no sh RouterB(config-if)#exit RouterB(config)#router eigrp 1 RouterB(config-router)#network 192.168.1.0 0.0.0.255 RouterB(config-router)#end RouterB# 查看路由表： RouterB#show ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set 172.16.0.0/24 is subnetted, 3 subnets D 172.16.1.0 [90/156160] via 192.168.1.1, 00:00:17, FastEthernet0/0 D 172.16.2.0 [90/156160] via 192.168.1.1, 00:00:17, FastEthernet0/0 D 172.