《办公楼供配电系统设计》.pdf

摘 要 围绕节能、经济、安全的设计理念，完成了某办公楼的供配电系统设计。 在熟悉了供配电系统的设计过程和相关要求后，根据国家建筑设计的主要设计规范和 设计依据，我按以下几个步骤展开设计，首先，我确定了办公楼的供配电方式，并绘制出 办公楼的主接线图。供配电系统设计采用的是单母线分段供电，为了满足供电要求，提高 供电系统的稳定性，电源实行一备一用。其次，我采用需要系数法对办公楼供配电系统中 的用电设备进行负荷计算，并计算出各点的短路电流。最后，根据计算参数，我完成了断 路器，隔离开关，熔断器，变压器，电流互感器，电压互感器等设备选型及校验工作，从 而绘制出配电系统图。 关键字：供配电系统 负荷计算 短路电流 1 Abstract According to the design concept of energy saving, economic and security ， I finished the power supply and distribution system design for an office building. After being familiar with the design process and requirements about power supply system, I designed with the following steps according to the main design specifications and design basis of national construction. First of all, I confirmed the power supply modes of the office building and plot a hookup of the office building. The power supply system was designed with single bus subsection power supply. In order to satisfy the power supply requirements and increase the stability of the power supply system, one power was used to sparing and the other using. Secondly, I used need coefficient method to make a power equipment load calculation for power supply and distributio