《变频器翻译_Michael》.doc

Memory setting of first frequency after power-off P049 Power down processing Setting range: 0, under voltage fault, then lock-in; 1, under-voltage fault, auto-resetting after power recover, not to start; 2, slow down and stop working when nearly under-voltage. 3, reserved; 4, reserved; The motion setting of converter after power-off and power recover. 0 P050 Reserved P051 Reserved P052 Reserved P053 Option of analog output Setting range: 0, output frequency of analog output, 0-Highest frequency corresponding to 0-10V; 1, output current of analog output, 0-2times of rated current of converter corresponding to 0-10V; This function is used as remote monitoring to output frequency and output power of converter by connecting with a DC Voltmeter or other equipments between AFM and COM terminal. The highest output voltage of AFM terminal is 10V. 0 P054 The corresponding output of the minimum analog quantity Setting range: 0.00-3.00V Setting of signal strength of the terminal under minimum analog quantity (0Hz or 0A). 0.0 P055 The maximum analog quantity Setting range: 5.00-20.00V 10.00 Page 21:Page22: The corresponding output Setting of signal strength of the terminal under maximum analog quantity (highest frequency or 2 times of rated current of converter). Attention: the parameter is used for revising the quantity of analog output, the actual highest output voltage of AFM terminal is 10V. P056 Options of display for starting up Setting range: 0, frequency (H, F); 1, motor current (A); 2, busbar voltage (U); 3, output voltage (u); 4, approximately speed of machine=output frequency﹡ratio of RPM (r); 5, PID fixed variable (y); 6, PID feedback quantity (L); 7, attribute data (J); 8, factory text reserved (d); 0 P057 Ratio of RPM Setting range: 0.01-100.00 The function is used for setting the ratio of display value of speed and working frequency, so as to enable the speed display value to keep consistent with the actual speed. 30.00 P