《SAEJ31-1986 液压式铲车举升能力》.pdfVIP

SURFACE REV. VEHICLE J31 MAR86 STANDARD Issued 1973-01 400 Commonwealth Drive, Warrendale, PA 15096-0001 Revised 1986-03 Supersedes J31 AUG84 Submitted for recognition as an American National Standard HYDRAULIC BACKHOE LIFT CAPACITY Foreword—This Document has not changed other than to put it into the new SAE Technical Standards Board Format. 1. Scope—This standard applies to hydraulically operated backhoes (see SAE J49). This standard describes a uniform over end and full swing arc lifting capacity rating for backhoes. It is based on the actual capacity of the machine to lift and support a load under stable conditions. Rated lift capacities will be specified for both the boom and the dipperstick and will be shown on a lift capacity chart Figure 1. 1.1 Purpose—The purpose of this standard is to provide a uniform method of rating hydraulic backhoe lift capacities. 2. Reference 2.1 Applicable Publication—The following publication forms a part of this specification to the extent specified herein. Unless otherwise indicated, the latest issue of SAE publications shall apply. 2.1.1 SAE PUB