基于3G网的远程控制系统设计和因特网技术英文原文及其汉语译文.doc

原文 A Design of Remote Monitoring System based on 3G and Internet Technology Shouxian WEN Key Lab of Intelligent Computing and Signal Processing of Ministry of Education, Anhui University Hefei, China Xingguo SUN Key Lab of Intelligent Computing and Signal Processing of Ministry of Education, Anhui University Hefei, China Lei XU Key Lab of Intelligent Computing and Signal Processing of Ministry of Education, Anhui University Hefei, China Xiaohui LI Key Lab of Intelligent Computing and Signal Processing of Ministry of Education, Anhui University Hefei, China Abstract ?Aiming at the low-rate and short-distance communication in existing temperature and humidity monitoring system, this paper designs a remote monitoring system based on 3G and Internet technology. This system consists of data acquisition module and data remote transmission module. Atmega128 is used to be as a master control chip of data acquisition module, which realizes the data acquisition and pretreatment, and the collected data is transmitted to the host node by the low-power wireless transmission module NRF905 which is installed on slave nodes, and then the converged data is transmitted to Internet by 3G module. The system can realize remote monitoring, centralized management and so on. The experimental results show that the system has the advantages of low installation cost, low consumption, high sensitivity, high accuracy, long-distance communication and high rate etc. Keywords-DS18B20; 3G; NRF905; Standard Definition (SD) card; Data acquisition subsystem; Data remote transmission subsystem. I. INTRODUCTION With the rapid development of computer networks and communication technologies, remote monitoring technology in the data acquisition and analysis has been widely used [1-7]. The traditional data acquisition system generally uses the computer (PC) ?slave node mode. Slave nodes use a wired connection so that wiring tedious, poor scalability. Especially for the vast space environment, if a wi