南昌商学院《ccna三》课程期末考试试卷.docVIP

南昌商学院《》Which of the following statements are true regarding RIP v1 and v2? (Choose three.) A．Both RIP versions use hop count. B．Both RIP versions can provide authentication of update sources.. C．Both RIP versions use 16 hops as a metric for infinite distance.. D．RIP v1 uses split horizon to prevent routing loops while RIP v2 does not. E．RIP v1 uses hold-down times to prevent routing loops while RIP v2 does not F．RIP v1 broadcasts routing table updates, while RIP v2 multicasts its updates. 2、 Router1 and Router2 shown in the topology have been configured with the no ip subnet-zero command. Which of the following valid VLSM network numbers could be used for the serial link between Router1 and Router2? (Choose two.) A．192.168.1.0/30 B、192.168.1.4/30 C、192.168.1.8/30 D、192.168.1.96/30 E、192.168.1.138/30 F、192.168.1.190/30 3、Refer to the graphic. Which of the following commands is used to configure switch port 2 for the host on VLAN 2? A．(config)# interface fastethernet 0/2(config-if)# switchport mode access(config-if)# switchport access vlan 2 B．(config)# interface vlan 2(config-subif)# switchport mode access 2 C．(config)# interface vlan 2(config-subif)# switchport mode trunk dot1q D．(config)# interface fastethernet 0/2(config-if)# vlan 2 4、Which subnet mask is represented by the /21 notation? A. 255.255.224.0 B. 255.255.248.0 C. 255.255.252.0 D. 255.255.240.0 5、What does OSPF use to reduce the number of exchanges of routing information in networks where large numbers of neighbors are present? (Choose two.) A、root router B、backup root router C、domain router D、 backup domain router E、designated router F、backup designated router 6．Refer to the graphic. If the network is running OSPF, which subnetworks can be assigned to the serial links between Router2 and the other routers shown in the diagram? A．192.1.1.4/30 and 192.1.1.8/30 B．192.1.1.32/30 and 192.1.1.160/30 C．192.1.1.96/30 and 192.1.1.100/30 D．192.1.1.160/