Dept.ofSystemDesignEng.,KeioUniversity.pptVIP

INTRODUCTIONto Hideki AOYAMA Lab. Research Fields Digital Style (Aesthetic) Design Current Aesthetic Design Processes Sketch Clay Model ProposedAesthetic Design Processes Chair Design System from Sketch Virtual Clay Modeling System Devices forVirtual Clay Modeling System Virtual Tool Result Constructed byVirtual Clay Modeling System Modeling SystemBased on High-Light Lines Results of ModelingBased on High Light Lines What’s Silhouette Line? What’s Boundary Line? Flow of developed system Input Silhouette Lines Constructed Model CAM Systems Method to determine the optimum feed rate Manufacturing Processes Thank you for your attention. Advanced CAM System Radial depth of cut : 2.0 mm Axial depth of cut : 3.0 mm Spindle speed : 1500 rpm Workpiece : S55C, feed rate : 0.06 mm/rev Tool : 2 flute square-endmill (f 10 mm) X Z Workpiece Tool 100 mm 100 mm D(90,10) A(30,20) B(30,80) C(90,90) Fa 2105 N Fb 1971 N Fc 1399 N Fd 1803 N Optimum fixturing force Starting point （0,0） Goal point （0,100） fixturing point C fixturing point D fixturing point A fixturing point B Y Management of Machine Tools with Internet and Construction Know-how Data-Base of Skilled Workers NC Machine Tool Parameters from NC Controler Management Commands The objective is to develop a system to manage the machine tools with the internet and the open technology of the NC control device, and to construct know-how data base of skilled workers by analysis their operations. Extracted know-how Personal computer Data base Analyzed NC data Network Developed Sensor Sensor Structure Coil E Coil W Coil N Coil S Sensor shank Ferromagnetic film x y Development of Sensor to detect Cutting Force Components, Cutting Torque, and Tool Deformation Flow Analysis for Injection Molding (Thixomolding) of Magnesium Alloy Based on FEM Recently, Mg alloy products are widely used for notebook-type personal computers, portable MDs, etc. because of easy recycling and rich resource. But the injection molding tech