4.3.4.HornPowerSupply-Fermilab.docVIP

POWER SUPPLY SYSTEMS (WBS 1.1.3) Introduction The extraction/primary beam power supply system consists of the power supplies for the beamline elements, their local controls and regulation equipment, the cables and connections from the power supplies to the 480 VAC power panels and the cables and connections from the power supplies to the devices that they drive. Table 4.31 summarizes the number and types of power supplies needed for the NuMI beamline. For beam tuning and focusing, each trim and quadrupole magnet has its own power supply. On the other hand the bend circuits use several 500 kW supplies in series (or for the V108 circuit a Main Ring Power Supply) in order to obtain the desired voltage levels. All power supplies are standard refurbished FNAL power supplies, with the exception of the kicker power supply and horn power supply. Some of the MI correction element power supplies will need to be built, but from a standard, existing FNAL design. The kicker and horn power supplies are designed and built specifically for the NuMI application. The horn power supply uses a transmission line to supply current to the two horns. The kicker power supply uses standard RG220 cable. The following sections describe the power supply system, starting with the conventional, mostly refurbished power supplies, then the kicker power supply and finally the horn power supply and its transmission line. Cables are covered briefly at the end. Type Number Kicker Power Supply (requires a 60 kV charging power supply) 1 Horn Power Supply (requires 2 charging power supplies and a transmission line) 1 PEI 240 kW (horn power supply charging power supplies) 2 Main Ring Style 1 PEI 500 kW 10 PEI 20 kW 23 MI Correction element power supplies 19 Table 4.31 Summary of Number of Power Supplies and Types System Description: Conventional Power Supplies Table 4.3-2 through Table 4.3-4 list the power supply circuits (except for the kicker), corresponding magnet types, numbers of