ADigitalControlApproachforaSingle-StageFlybackPFC.pptVIP

Matlab Code 穩態特徵曲線 Buck Converter Circuit X-Y Curve Steady State Curve 作業 完成Duty=0.1, 0.3, 0.5, 0.7, 0.9 之特性曲線 用Matlab將曲線繪出在同一張圖上 將Psim所得之圖與Matlab計算之圖做比較，並分析可能不相等原因? Mathcad Code Static Curve for Buck converter Bode plot 參考書目 REFERENCES [1] M.Sanz, A.Lazaro? “Improvement of Power Electronics Education with an Interactive Electronic Book based on MathCAD?” IEEE Power Electronics Education? 2005. [2] Cristian Domnisoru? “Using MATHCAD in Teaching Power Engineering?” IEEE trans On Education? VOL. 48?NO.1? FEBRUARY 2005. [3] R. W. Larsen? “Introduction to MATHCAD?” Englewood Cliffs? NJ: Prentice-Hall? 1999. [4] Mathcad User’s Guide? MathSoft? Cambridge?MA? 2001. [5] Alan Felzer, “Introduction to MathCAD,” 2003 [6] ST AN1089 Application Note [7] Lai, J.-S.; Chen, D.? “Design consideration for power factor correction boost converter operating at the boundary of continuous conduction mode and discontinuous conduction mode.” in Proc. IEEE Appl. Power Electron. Conf, 7-11, Mar. 1993. pp.267 – 273 */132 clear all; L=1E-3; Vd=100; Ts=50E-6; %IL=zeros(100,1); ILB_max=Vd*Ts/(8*L); N=2*ILB_max/0.01; i=1; while(iN) IL(i)=0.01*i; i=i+1; end M=size(IL); for i=1:1:100 Duty=i*0.01; ILB_matrix(1,i)=Duty*Ts/2/L*(Vd-Duty*Vd); ILB_matrix(2,i)=Duty; end plot(ILB_matrix(1,:),ILB_matrix(2,:)) hold off; grid on; figure(1); for j=1:2:9 D=0.1*j; ILB=D*Ts*(Vd-D*Vd)/(2*L); for i=1:1:M(2) if (IL(i)ILB) ratio(1,i)=D; ratio(2,i)=IL(i); else ratio(1,i)=D^2/(D^2+0.25*IL(i)/ILB_max); ratio(2,i)=IL(i); end end plot(ratio(2,:),ratio(1,:)); hold on; end 初始值 特徵曲線 電感電流極限值 Io D=0.9 D=0.7 D=0.5 D=0.3 D=0.1 CCM DCM Duty Iload Io Io Io 與計算結果有差異!!! Step-Down DC-DC Converter: Limits of Cont./Discont. Conduction CCM DCM BCM (a) (b) (c) combine (a) and (b) ,we can plot (c) ? CCM DCM Boundary Curve 台灣新竹?交通大學?電機與控制工程研究所?808實驗室 電力電子系統晶片、數位電源、DSP控制、馬達與伺服控制 .tw/ Lab-808: Power Electronic