ElectronicCircuitsI.docVIP

Department of Electronics and Communication Engineering QUESTION BANK Subject : Electronic Circuits - I Class : III ECE Sub Code: EC2205 UNIT – I PART – A 1.What is biasing? Biasing means switching on the transistor by external means or by applying dc voltages to establish a fixed level of current and voltage. 2.What are the types of biasing? 1.fixed bias 2. self bias 3. base bias 4. base bias with emitter feedback 5. base bias with collector feedback. 3.Define DC load line. It is a line drawn on the output characteristics of a transistor circuit which gives the values of Ic Vce when no input signal is given under dc conditions. 4.Define quiescent point. It is a point on the dc load line which gives the values of Ic Vce when no signal is applied. 5.Define AC load line. It is a line drawn on the output characteristics of a transistor circuit which gives the values of Ic Vce when input signal is given under AC conditions. 6.Define stability factor. It is defined as the rate of change of collector current with repect to reverse saturation current. 7.Why voltage divider bias is preferred over other types of biasing ? This biasing is always preferred because the stability of the Q point is maintained constant. 8. Which biasing is called as universal bias stabilization? Voltage Divider Bias. 9.Define Stabililty. The stability of a system is a measure of the sensitivity of a network to variations in its parameters. 10.What are the parameters that affect the stability . Change in ( , Vbe , Ico. 11.Define stability factor w.r.t ( , Vbe , Ico . S (Ico) = (Ic / (Ico S (Vbe) = (Ic / (Vbe S (() = (Ic / ( ( 12. Write the difference between FET BJT . BJT FET 1.There will be linear relationship There is a non linear relationship Between input and output Between input and output. 2.T