克莱斯勒标准 LP-463PB-31-01 漆膜的耐液性要求(中文版).docVIP

DAIMLERCHRYSLER CORPORATION No: LP-463PB-31-01 Laboratory Procedure Date Published: 2005-02-22 Category Code: J-1 Change: H RESTRICTED: No RESISTANCE OF PAINT FILMS TO VARIOUS FLUIDS 漆膜对各种液体的抵抗力 1.0 GENERAL 1.1 Purpose 目的 This procedure describes the method for determining resistance of paint films and substrates to an array of vehicle and commercial fluids. 此过程描述了测定漆膜和底材对一批汽车和商品液体抵抗力的方法。 2.0 SPECIAL TEST EQUIPMENT MATERIALS专门的实验设备和材料 The required materials and the method used for testing are contained in Table 1. The methods are described in detail in Section 6.0. 表1包含了实验要求的材料和使用的方法。方法在6.0部分做了详细的叙述。 TABLE 1: FLUID RESISTANCE TESTS 表1： 抗液体能力的实验 MATERIALS 材料 METHOD 方法 EXTERIOR 外部 INTERIOR 内部 UNDERHOOD 车下面 Anti-Freeze MS-7170, 50/50 mix: Antifreeze/Water 防冻（MS-7170, 50/50最小：防冻剂/水） B Armor All清洗液 B B B Brake Fluid MS-4574 刹车液（MS-4574） B 无铅高芬芳汽油 C for Metals B for Plastics 柴油机液 E 发动机油（MS-9754）， SAE 10W30 B 太阳油 – Coppertone牌水宝宝30SPF 传动液（MS-9602） B 水 B B C Warm Water Immersion 温水浸泡 G Windex牌玻璃清洁剂 B B B Windshield Wiper Solvent MS-3037 挡风玻璃清洁溶剂 B 水和肥皂点测试 F F 酸滴实验 H H Acid Spot Test - Hydrochloric Acid Solution in Sunlamp Cabinet 酸滴实验 – 太阳灯箱内的盐酸溶液 I I Solvent Wipe Resistance 溶剂擦拭抵抗力 J J 发动机去污剂 B Power Steering Fluid MS-9602 动力转向液（MS-9602） 3.0 SAFETY PRECAUTIONS 安全防范 This procedure may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 4.0 CONDITIONING 条件 The test surface shall be a panel or part as specified in the applicable Material Standard and aged for 72 hours prior to testing. 测试的表面应该是在适用材料标准中指定的测试板或零件并且在进行实验前老化72小时。 5.0 SAMPLING 取样 Refer to the applicable material. 参考适用材料 6.0 PROCEDURE*** 步骤 After testing th