第四讲_模数转换器ADC技术方案.pptVIP

正弦波 1K-10KHz 正弦波 1K-10KHz 幅值调整 波形频率选择 波形输出A 幅值调整 波形输出B 波形频率选择 1) 用1根信号线连接实验箱左侧信号源的波形输出A端口和“A/D输入”模块的“ADCIN0”插座注意插头要插牢、到底。这样，信号源波形输出A的输出波形即可送到ICETEK–F2812-A板的AD输入通道0。 2) 用1根信号线连接实验箱左侧信号源的波形输出B端口和“A/D输入”模块的“ADCIN1”插座注意插头要插牢、到底。这样，信号源波形输出B的输出波形即可送到ICETEK–F2812-A板的AD输入通道1。 3) 设置波形输出A： - 向内侧按波形频率选择旋钮，直到标有正弦波的指示灯点亮。 - 上下调节波形频率选择旋钮，直到标有1KHz-10KHz的指示灯点亮。 - 调节幅值调整旋钮，将波形输出A的幅值调到最大。 main() { InitSysCtrl();//初始化cpu DINT;//关中断 InitPieCtrl();//初始化pie寄存器 IER = 0x0000;//禁止所有的中断 IFR = 0x0000; InitPieVectTable();//初始化pie中断向量表 // Interrupts that are used in this example are re-mapped to // ISR functions found within this file. EALLOW; // This is needed to write to EALLOW protected register PieVectTable.ADCINT = adc_isr; EDIS; // This is needed to disable write to EALLOW protected registers AdcRegs.ADCTRL1.bit.RESET = 1; //Reset the ADC module asm( RPT #10 || NOP); // Must wait 12-cycles (worst-case) for ADC reset to take effect AdcRegs.ADCTRL3.all = 0x00C8; // first power-up ref and bandgap circuits AdcRegs.ADCTRL3.bit.ADCBGRFDN = 0x3; // Power up bandgap/reference circuitry AdcRegs.ADCTRL3.bit.ADCPWDN = 1; // Power up rest of ADC // Enable ADCINT in PIE PieCtrlRegs.PIEIER1.bit.INTx6 = 1; IER |= M_INT1; // Enable CPU Interrupt 1 EINT; // Enable Global interrupt INTM ERTM; // Enable Global realtime interrupt DBGM // Configure ADC AdcRegs.ADCMAXCONV.all = 0x0001; // Setup 2 convs on SEQ1 AdcRegs.ADCCHSELSEQ1.bit.CONV00 = 0x0; // Setup ADCINA3 as 1st SEQ1 conv. AdcRegs.ADCCHSELSEQ1.bit.CONV01 = 0x1; // Setup ADCINA2 as 2nd SEQ1 conv. AdcRegs.ADCTRL2.bit.EVA_SOC_SEQ1 = 1; // Enable EVASOC to start SEQ1 AdcRegs.ADCTRL2.bit.INT_ENA_SEQ1 = 1; // Enable SEQ1 inter