屋面RA-CTRoofingforBahamarProject要点详解.ppt

9. RA-CT 抗风压 Testing Application Standard (TAS) 114-95 Appendix J, Test Procedure for 12 Foot By 24 Foot Simulated Uplift Pressure Resistance Of Roof System Assemblies 静态风压情况下验证屋顶系统的稳定性(新型屋面 试验中至少三个同等规格的样件) 9. RA-CT 屋面施工前试验 Electronic Leak Detection Testing (ELD电子检漏测试) is required on the completed membrane for all looselaid system applications. ? The slab or decking onto which the membrane or roof system is laid is electrically conductive—usually metal or concrete. ? The membrane itself is an electrical insulator Technician using the dry tester. Defect identified by the dry tester Electrical Earth Leakage Testing - Dry Method(Earth (ground) Leakage Detection in UK)If a roofs waterproof membrane is continuous, it may act as an electrical insulator of an electrically conductive substrate below However, if any defect in the membrane (leak position) exists this will allow a pathway for an electrical current to be discharged to earth. The test equipment introduces a stabilised direct current (d.c) over the dry roof membrane. By moving over the dry waterproof membrane with the portable test instrument an experienced technician can pinpoint defects that will allow water to enter into the roof construction. 10.RA-CT 屋面施工中试验 施工过程质量控制 -FIELD QUALITY CONTROL 淋水试验Water-Spray Test: After completing the installation of 300 square-foot- minimum area of concrete roof tile assembly, test assembly for water penetration according to AAMA 501.2 in a 2-bay area directed by Architect. (Pressure of 30-35psi (approx 2-2.4 bar)) at a distance of 0.3m from it for a period of 5 minutes for 1.5m of joint. 10.RA-CT 屋面施工中试验 施工过程质量控制 -FIELD QUALITY CONTROL 抗拔试验 Fastener Withdrawal Resistance: Test fasteners in accordance with ANSI/SPRI FX-1 “American National Standard, Standard Field Test Procedure for Determining the Withdrawal Resistance of Roofing Fasteners”. Use a portable pullout tester utilizing a hydraulic or electronic load cell. Remove any roofing material (i.e. waterproofin