毕业设计论文多工位母线加工机冲孔机构设计论文.docVIP

摘 要 多工位母线冲压机在机械方面由冲孔单元、剪切单元和折弯单元组成, 装配于同一工作台上形成三工位, 分别完成对铜、铝母线的冲孔、剪切和折弯、压花等工作。本次设计主要是冲孔结构单元的设计。在的程序中，孔是主要的加工。后续的加工，孔。因此后续加工的成败及顺利与否，和孔的结果是。ABSTRACT Multi-station press bus from the punching unit in the machinery, cutting unit and bending units, the assembly formed in the same three-position bench, were completed on copper, aluminum bus bar punching, shearing and bending , embossing and so on. This design is mainly the design of structural unit of punching. In the machining process, punching one of the main processing. Subsequent processing of many processes, which is the most basic aspects of punching. Therefore, the success of subsequent processing and smooth or not, and punching the results are closely related. The subject of comprehensive and strong, you can consolidate the knowledge learned to improve my skills and knowledge of the integrated use of a certain complexity of solving practical engineering problems.Bus for multi-station machine work characteristics and processing requirements, multi-bit bus on the punching machine for structural analysis and design unit, and the punching unit to optimize the frame structure; punching unit of convex and concave mold and the upper and lower Die support structure design, learn to institutions, mold, hydraulic and other aspects of the comprehensive application of knowledge, initial grasp of mechanical design, mold design, hydraulic and other aspects of knowledge and methods to improve mechanical design, engineering capabilities. Access to all aspects of multi-site on the institutional design of bus punching the literature, including books, journals, papers, design manual, mechanical equipment and equipment technical parameters. By understanding the knowledge, the development of domestic and foreign, manufacturing and technological conditions, the level of research and future trends there is a specific and detailed understanding. And then go out into the plant through its internship with perceptual knowledge, through