路由基础第十二章概要.ppt

注意： 点到点的要配置子接口的DLCI号；点到多点的子接口DLCI号无须配置. 这是因为点到点是不同的子接口对应不同子网，他们要求有自己的单独的DLCI号； 点到多点是使用一个子接口来建立多条PVC，这些PVC连接到远端的路由器的多个子接口或物理接口。 每个接口都使用它自己的逻辑DLCI号；因为是一个子接号对多个接口，所以做点到多点的子接口不能同时使用不同的DLCI号。 了解 Frame Relay 工作过程 配置 Frame Relay 配置 Frame Relay 的子端口 查看 Frame Relay 信息 本章总结 完成本章的学习后，你应该能够掌握： Purpose: This chapter provides a brief overview of Frame Relay operation. It also explains how to configure Frame Relay on a Cisco IOS device. Timing: This chapter takes approximately 1.5 hours to present. Note: This section has a laboratory exercise in which students configure a Frame Relay PVC on a serial connection. They will also configure Frame Relay subinterfaces. Contents: Objectives—This section explains what the student will be able to do at the end of this chapter. Frame Relay Overview—This section describes how Frame Relay operates. Configuring Frame Relay—This section describes how to configure Frame Relay on a Cisco IOS device. Configuring Frame Relay Subinterfaces—This section describes how to configure Frame Relay subinterfaces. Laboratory Exercise—Students will configure a Frame Relay PVC. Summary—This section summarizes what was taught in the chapter. Purpose: This figure states the chapter objectives. Emphasize: Read or state each objective so each student has a clear understanding of the chapter objectives. Transition: The next section presents an overview of Frame Relay. Purpose: This figure provides a big-picture definition of Frame Relay. Emphasize: Frame Relay is used between the CPE device and the Frame Relay switch. It does NOT affect how packets get routed within the Frame Relay cloud. Frame Relay is a purely Layer 2 protocol. The network providing the Frame Relay service can be either a carrier-provided public network or a network of privately owned equipment serving a single enterprise. Make a clear distinction between DCE, DTE, and CPE. Emphasize that Frame Relay over SVCs is not discussed in this chapter because it is not widely supported by service provi