SBS卷材防水施方案(四合院).docVIP

SBS防水卷材施工方案 四、施工准备： 1、施工组织机构 该项目工程人员安排如下：??? 管理人员??? 人 技术人员??? 人编制方案、制定措施、整理资料、技术交底???? （2）采购人员 1人 材料供应及时通知检验???? 主要施工人员???? 人 清除层面杂质灰尘，涂刷底层涂料、铺贴卷材、表层处理1）主要材料选择???? 根据设计，本工程屋面防水层采用牌SBS改性沥青防水卷材4mm厚单层热熔施工做法。 （2）设备机械配备???? 主要施工机具（工具）设备????① 小平铲、扫帚??清理基层 。????② 滚动刷???涂胶粘剂（冷底油）。????③ 铁桶???分装胶粘剂（冷底油）? 液化气喷枪??热熔卷材用。????壁纸刀?? 把 裁剪卷材用。????卷尺??? 个 度量尺寸用。基层处理→涂油→→卷材试铺→铺贴卷材→→质量检验→成品保护。％％％％、成品保护???? （1）施工人员应穿软质胶底鞋，严禁穿带钉的硬底鞋。在施工过程中，严禁非本工序人员进入现场。???? （2）防水上堆料放物，都应轻拿轻放，并加以方木铺垫。(3)施工结束后要注意成品保护，严禁在防水层上堆放重物以及带棱角有尖刺的物品（如：钢筋，机械，建筑垃圾）。???? （）防水层验收合格后，可直接在防水层上浇注细石混凝土或砂浆作刚性保护层，施工时必须防止施工机具如手推车或铁锨损坏防水层。???? （）施工中若有局部防水层破坏，应及时采取相应的补救措施，以确保防水层的质量。 pump speed (c) is proportional. A, a party; B, the second party; C/third party. ... A, increasing amplitude increases with the increasing speed of b, the amplitude is independent of load amplitude decreases with the increase of load c, d, amplitude increases as the load when the static friction occurs when the turbo-generator shaft (b). A vibration phase angle is constant b changes, vibration phase angle is c, sometimes constant vibration phase angle and sometimes d, vibration phase angle start, later increased the load on the turbine swing value to a slow rate of speed control system (a). Inversely proportional to the proportional to a, b, c, a nonlinear relationship between d, independent of when the rotor critical speed lower than the speed (d) only when the oil film oscillation may occur. A, 4/5 b, 3/4 c, 2/3 d, at the sliding-parameter shutdown of 1/2, (c) steam turbine overspeed test. A, b, c after taking safety measures, no d, lead on sliding-parameter shutdown process and after approval ratings down compared with (b). Capacity positive differential expansion of b, a, prone to the negative expand difference c, differential expansion does not change d, change little differential expansion turbine shutdown when the coastdown speed, due to the blast and Poissons effect, the rotor will appear (a) sudden increas