空气压缩机机身铣三斜面专用机床夹紧系统、液压系统机械CAD图纸设计论文.doc

摘 要关键词：Abstract Special combined machine tool is a mechanical device for universal, applicable to mass production, is quite flexible, high machining accuracy, improve production efficiency, reduce labor intensity. This paper is the design requirement of social production. According to the relevant data of the existing air compressor machine, machining process air compressor airframe design, fixture design, combination milling body three inclined planes of the hydraulic system. On the basis of this new processing technology is proposed and in line with the new technology of special machine tool for processing scheme, make improvement and innovation of the products more suitable for factories and customer needs. Based on the combination of the three bevel milling fixture design process, special fixture of milling three and inclined boreholes were comprehensive design. From the dimension design of fixture to the two side pin constrained degrees of freedom positioning scheme to the calculation of machining surface precision: the design of hydraulic feed system, this paper also use a lot of space. Key according to the basic principle of hydraulic system, draw the diagram of hydraulic system reasonable; according to the main parameters of hydraulic component has been selected, combined with the specific practice and experience in the design process in the design of the modular machine tool, describes the general parts (such as hydraulic slider) selection and special parts (such as the design and calculation of main spindle box). Finally, I hope this design fixture and hydraulic system can meet the design requirements, and can achieve good effect in actual application. Key words:unit built machine tool ;special requirements ;craftwork ;drill jig ;hydraulic pressure 目 录 要 III Abstract IV 目 录 V 1 绪论 1 1.1 力源压缩机有限公司简介 1 1.2 本课题的意义目的 1 1.3 本设计的技术要求 1 2 压缩机机身铣三斜面加工工艺规程设计 2 2.1工艺方案的制定 2 2.2 产品图纸及结构分析 2 2.3 毛坯分析、要求及形式的确定 3 2.3.1 毛坯种类的选择 3 2.3.2 选择毛坯应考虑的因素 3 2.3.3 确定毛