NVH性能集成与开发案例Jun重点.ppt

整车NVH性能集成与开发案例-Case Studies;目录;异响;1. 某欧系车Idle异响;2. 某欧系改造车离合异响和松油门异响;2. 某欧系改造车离合异响和松油门异响;3. 某SUV开到60公里/小时以上时前端异响;4. 某发动机在WOT 5500rpm时发动机的口哨声;5. 某车开到100公里/小时以上时听到口哨声;6. 某电动车在能量回收时有冲击声;车内有轰鸣声/振动;7.某SUV在粗糙路面时的轰鸣声;What: At 2200 ermp, huge noise and floor vibration (4 wheel drive vehicles only) Analysis/tesing: Coupled structure-fluid analysis plus Transfer Path Analysis (hybrid) Root causes: First bending mode (107hz) of P/T and driver line being excited Solution: Dynamic absorber, Stiffen brackets, and Reduce mount rates. ;;;8. 某CUV 动力传动系统噪音与振动;;9.某SUV在POT时有轰鸣声;10.某SUV在WOT时有轰鸣声;车内振动噪声过大;What: Reduce the road noise of a minivan Analysis: SEA Technology Testing: Road Dynamometer, Intensity map on Dynamometer;Root Cause: Poor sealing for the lower of the sliding door A weak carpet system Solution: Better sealing and better carpet system A SAE 2003 NV Conf paper published for this project;系统激发的声音;What: Power steering pump very noisy at cold start (0-10 oF) Testing: Many iterations in cold chamber. Root Cause: Cold temp Very high viscosity Cannot pass filter effectively Vacuum in pump Fluid cavitations big noise Solution: Use slightly large filter size ;What: Relatively high volume noise when you turn on the switch for washer fluid Test: Component, subsystem, and vehicle level measurement Root Cause: Lack isolation of fluid tank with body; Fluid tank too close to dash panel Solution: Isolate fluid tank from body;13. Washer FluidPump Noise;What: High volume ABS noise. Sounds like a hammer hitting the dash panel Analysis: Vibro-acoustic (FEM-BEM) Root Cause: switch caused dynamic brake fluid pressure variation which is fed back to master cylinder Solution: Reduce pressure variation ;14. 某SUV ABS 噪音 ;14. 某SUV ABS 噪音 ;15. 某SUV冷却风扇噪音过大;Thanks