单组份环氧富锌底漆用途.docVIP

Intended Uses 用途 新建筑和维修用高性能涂料，易施工、快干、耐磨、防腐性能好。 As a high performance paint for new construction and maintenance. Easy application, quick dry, abrasion resistance, goog anti-corrosive property Product Information产品简介 灰色，单罐装，施工温度可低至-10℃ Grey. one package, the temperature to be applied can be low to 10℃ Application details 产品数据 Volume Solids 固体份 ≥40% Dry Flm Thickness干膜厚度 40 microns equivalent to 100microns of wet film 40 微米相当于100微米湿膜厚 Theoretical Coverage 理论涂布率 4.4m2 /Kg 4.4平方米/公斤 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 one package 单罐装 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conwentional Spray 传统喷涂 Not Recommended 不推荐采用 Thinner 稀释剂 C003 Cleaner 油漆设备清洗剂 C003 Pot Life 使用期 Not limit 不限制 Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature 底材温度 Touch Dry 表干 （min） Hard Dry 硬干 H） Over coating Interval 覆涂间隔 Mix最短 Max最长 5℃ 23℃ 35℃ 30 5 3 2 1 0.5 2 hour 小时 1 hour 小时 0.5 hour 小时 Two months 两个月 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 40Kg in 20 liter container 40公斤装于20公升容器 Flash Point 闪点 ≥35℃ Specific Gravity 比重 Approx2.30Kg/L 大约2.30公斤/公升 Specification and Surface preparation 技术要求及表面处理 The steel surface: Blast clean to Swedish Standard Sa2.5 or rust-removed manually or with power tool to Swedish Standard St3 钢材表面：喷砂处理达瑞典标准 SIS055900 Sa2.5级或手工、动力工具除锈至St3级 Limitations 限制 Should overcoat with temperarily sealer protective coat or subsequent coat in a short time to avoid producing zinc salt. 须尽快复涂暂时性防护漆或封闭漆或后道涂料，否则表面易产生锌盐。 Safety Precautions 安全措施 This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-base