土木工程专业英课后翻译参考(二班).docVIP

专业英语课后翻译参考 Unit1 2、词组翻译 （1）受弯构件 （2）临界屈曲荷载 （3）长细比 （4）短柱 （5）折减模量 （6）effective length （7）residual stress （8）trial and error approach （9）radius of gyration （10）tangent modulus 3、英译汉 (1)This ideal state is never achieved in reality, however, and some eccentricity of the load is inevitable. 在现实中,这种理想状态从来没有达到，然而，一些荷载偏心是不可避免的 (2)In many instances the members are aslo called upon to resist bending, and in these cases the member is a beam-column. 在许多情况下，需要构件能够抵抗弯矩，并在这些情况下，构件是梁柱。 (3)If the member is so slender that the stress just before buckling is below the proportional limitthat is, the member is still elasticthe critical buckling load is given by Q. 如果该构件是是细长，则在屈曲前应力就低于比例限制也就是说，该构件仍然是弹性由公式Q 给出该临界屈曲荷载。 (4)The ratio L/r is the slenderness ratio and is the measure of a compression member’s slenderness, with large values corresponding to slender members. L/r 是长细比，是衡量受压构件的长细的一种方法，对于细长的构件它具有较大值。 (5)If the stress at which buckling occurs is greater than the proportional limit of the material, the relation between stress and strain is not linear,and the modulus of elasticity E can no longer be used. 如果在构件发生屈曲时应力的大小超过了材料的比例极限，应力与应变之间的关系不是线性的，弹性模量E的不能再使用 (6)If the member is more stocky, as the one in Fig.1.1b, a larger load will be required to bring the member to the point of instability. 如果构件更为粗壮，就像图1.1b所示的，那么需要更大的荷载来使构件产生失稳。 (7)The tips of the flanges, for example, cool at a faster rate than the junction连接 of the flange and the web. This uneven cooling induces stresses that remain permanently. 例如，轮缘的尖部比轮缘的结合部以及中部冷却的速度更快。这种不均匀冷却引起的应力会长久的存在。 (8)In 1947, F.R.Shanley resolved the apparent inconsistencies in the original theory, and today the tangent modulus formula, Eq.1.3, is accepted as the correct one for inelastic buckling. 1947年，FRShanley解决原有理论的明显的矛盾，所以现在切线模量计算公式 1.3，作为非弹性屈曲正确公式是被人所接受的。 (9)The composite curve, called a column strength curve, completely describes the stability of any column of a given material. 复合曲线，称为柱强度曲线，完全描述了任何一个给定的