ICT GR228X.docVIP

MTG ---MXI to GenRad board Functional blocks are MXI to GR bus interface, low speed controller, data expander 模块功能包含:：MXI 到 GR 的内部总线接口, 低速控制器，数据扩展 RTC--- Run Time Controller BUS interface for the analog subsystem directs coordinates pin board activities; data transfers between cpu and the digital subsystem 模块功能包括：模拟子系统直接控制和调整pin卡的总线接口，数字子系统和CPU之间的数据转换 CST---Clock/Sync/Trigger board Provides event timing and event detection Reference Driver/Sensor reference Supplies programmed dc reference voltages for the D/S pin boards 提供事件定时和事件检测 提供 Driver/Sensor 的参考 为D/S pin卡提供可编程的DC参考电压 CFB--- Custom Function Board DSM--- Deep Serial Memory AFTM ---Analog Functional Test Module ICA ---In-Circuit Analog Module Analog Functional Test Module (AFTM) 模拟功能测试模块 ??Functionally tests analog networks 模拟功能性测试网络 ??Measures D/A converters D/A 转换器测量 ??Provides frequency response of crystal oscillators 提供晶体震荡频率响应 ??Performs pulse width measurements 脉冲宽度测量 The AFTM module resides in the pin cage and takes up one driver/sensor slot. When installed with a DSM board the AFTM will always be in the higher numbered slot after of the DSM board. The board contains: AFTM 模块放在pin笼里并占用一个 Driver/Sensor 槽。当同时安装了DSM卡的时候，AFTM 一直都j紧跟在DSM卡后面, 卡包含: ??16 bit DC voltmeter 16位直流电压计 ??True RMS AC voltmeter 正均方根 交流电压计 ??16 Bit sampling voltmeter 16位采样电压计 ??AC/DC source AC/DC 源 ??TTL signal output 逻辑信号输出 ??Frequency/Timer interval meter 频率/时间 间隔计量器 ??High frequency scanner 高频率扫描仪 Custom Function Board The Custom Function board (CFB) provides users the ability to create application specific hardware to meet their specialized testing requirements. Prior to this board’s availability, when unique test circuitry was required, hardware had to be built into each test fixture. Now circuits can be mounted within the test system where these added resources can be used with a variety of test fixtures. The CFB, shown in the following figure, occupies on