Android启动过程代码分析.docVIP

Android 启动过程代码分析（上） Android, 代码 开机过程中无线模块的初始化过程;如果sim卡锁开启，或者pin被锁住的时候，会要求输入pin或者puk，但是这个解锁动作必须在系统初始化完成以后才能进行。（图形系统都还没有初始化怎么输入密码阿？）当系统初始化完成以后会调用 wm.systemReady()来通知大家。这时候该做什么就做什么。开机过程中无线模块的初始化过程：rild 调用参考实现??Reference-ril.c (hardware\ril\reference-ril) 中的函数：const RIL_RadioFunctions *RIL_Init(const struct RIL_Env *env, int argc, char **argv)??ret = pthread_create(s_tid_mainloop, attr, mainLoop, NULL);static void *mainLoop(void *param)??ret = at_open(fd, onUnsolicited);??RIL_requestTimedCallback(initializeCallback, NULL, TIMEVAL_0);在 initializeCallback 函数中对猫进行了初始化。 static void initializeCallback(void *param) { ? ? ATResponse *p_response = NULL; ? ? int err; ? ? setRadioState (RADIO_STATE_OFF); ? ? at_handshake(); ? ? /* note: we dont check errors here. Everything important will ? ?? ? be handled in onATTimeout and onATReaderClosed */ ? ? /*??atchannel is tolerant of echo but it must */ ? ? /*??have verbose result codes */ ? ? at_send_command(ATE0Q0V1, NULL); ? ? /*??No auto-answer */ ? ? at_send_command(ATS0=0, NULL); ? ? /*??Extended errors */ ? ? at_send_command(AT+CMEE=1, NULL); ? ? /*??Network registration events */ ? ? err = at_send_command(AT+CREG=2, p_response); ? ? /* some handsets -- in tethered mode -- dont support CREG=2 */ ? ? if (err 0 || p_response-success == 0) { ? ?? ???at_send_command(AT+CREG=1, NULL); ? ? } ? ? at_response_free(p_response); ? ? /*??GPRS registration events */ ? ? at_send_command(AT+CGREG=1, NULL); ? ? /*??Call Waiting notifications */ ? ? at_send_command(AT+CCWA=1, NULL); ? ? /*??Alternating voice/data off */ ? ? at_send_command(AT+CMOD=0, NULL); ? ? /*??Not muted */ ? ? at_send_command(AT+CMUT=0, NULL); ? ? /*??+CSSU unsolicited supp service notifications */ ? ? at_send_command(AT+CSSN=0,1, NULL); ? ? /*??no connected line identification */ ? ? at_send_command(AT+COLP=0, NULL); ? ? /*??HEX character set */ ? ? at_send_command(AT+CSCS=\HEX\, NULL); ? ? /*??USSD unsolicited */ ? ? at_send_co