丙烯酸改性氯化橡胶面漆.docVIP

丙烯酸改性氯化橡胶面漆 Intended Uses 用途 涂布于中等至严重腐蚀性环境下的钢板内外表面，耐磨损、碰撞、海水和脂烃类溶剂。在 一定程度上耐鱼油和其他动植物油，保光保色性好、不耐芳经溶剂。 As a finish on interior and exterior surface of steel in moderately and severely corrosive environments. It provides a coating, resistant to abrasion, impact, seawater, animal and vegetable oil, good gloss and color retention. ?Not resistant to aromatic solvent. Product Description 产品简介 黑色、白色或可供选择的颜色。物理性干燥。 Black, white and other selected colors. Physical drying. Product Information 产品数据 Volume Solids 固体份 45% Dry Film Thickness干膜厚度 50microns equivalent to 110 microns wet 50微米相当于110微米湿膜厚 Theoretical Coverage 理论涂布率 9.0m2 /Kg 9.0平方米/公斤 Practical? Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Application Details 施工详述 ? Mix Radio 混合比 One package 单罐装 Method of Application 施工方法 Airless Spray 无空气喷涂 Recommended 推荐采用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conventional? Spray 传统喷涂 Recommended 推荐采用 Thinner 稀释剂 C001 Cleaner 油漆设备清洗剂 C001 Storage 贮存期 One year 一年 Drying time 干燥时间 ? Substrate Temperature底材温度 Touch Dry 表干 （H） Hard Dry 硬干 （H） Over coating Interval 覆涂间隔 Mix最短 Max最长 20 ? 3-4 ? 24 ? 4 hours 小时 ? Not limit 不限 Storage and Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions ???贮存于阴凉干燥处 Pack size??? 包装规格 20Kg in 20 liter container 20公斤装于20公升容器中 Flash Point? 闪点 38 Specific Gravity? 比重 1.1Kg/L 1.1公斤/公升 Specification and Surface preparation 技术要求及表面处理 Steel surface: Blast to Swedish Sa2.5 or rust-removed manually or with power tool to St3 prior to application. 钢材表面：喷砂处理至瑞典标准Sa2.5级或手工，动力工具除锈至 St3级（涂装前）。 Limitations 限制 Preceding coat: ?Chlorinated rubber paint, etc. 前道配套涂料：氯化橡胶涂料等 Safety ? Precautions ? 安全措施 The product must be used in painting area by professionals. When painting , please be sure to refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying the product. The product is a kind of solvent-based paint. In order to avoid the accident or dangerous