油水分离器试验程序.docVIP

油水分离器试验程序 试验前应具备的条件。 Test condition 管路安装正确性和完整性。Inspection pipe systems have been installed correctly and completely. 管路密性试验结束Inspection pipe systems tightness test have been finished. 确定各部分的电气配线按要求安装，电动机、自动排油装置、油分浓度计等各自的供给电源的正确性。安全、故障报警模拟试验discharge stop device （三）运行功能试验Running Function Test 1 注意油水分离器的各压力表的情况记录，注意压差。 Record readings of the pressure gauges at various parts of the oily water separator, and check for different pressure. 2 确认自动排油装置的当作是否正常。 Check that the function of automatic oil drain system is normal. 3通过该装置的排出侧的取样口的取样，目测确认处理水的状态。 Take a sample from cock on the discharge side of the oily water separator, and check the properties of treated water visually to assure no irregular phenomena caused. 系泊试验记录表（MOORING TEST RECORD） 船名 项目： Ship name: Article: 项目号 试验日期 记录单序号： Job No: Date: Record No： 设备名称： 设备编号 Eqt Name: Eqt Serial No: 油水分离器试验记录 内 容Description 单位Unit 结果Result 油水分离器和泵Oily Water Separator and Pump 冷/热态绝缘电阻Cold/Hot Insulation Resistance MΩ 起动/工作电流Start/Running Current A 　 油份浓度计报警Bilge Alarm 油分浓度高报警，排舷外三通阀关闭15ppm alarm and overboard stop 用清水检查零位Zero Point with clean water 三通阀功能试验Three-way valve function test 油份浓度低于15ppmOil Content within 15ppm 油份浓度高于15ppmOil Content over 15ppm 功能试验Function test 油排出电磁阀Oil discharge Solenoid Valve 试验结果： 检验员 验船师 船东 Inspector: Surveyor: Ship Owner: QAD-FM-O12 版本号：A/0 生效日期：2008-01-01