桥机 桥式起重机 车安装中英文EOT Crane Installation.docVIP

厂 房 桥 机 安 装 施 工 措 施 Power House EOT Crane Installation Construction Program 批准： Approve: 审核： Verify: 校核： Check: 编写： Compile: 目录Content I. 施工概述 Brief 3 1. 工程内容：Content of work 3 2. 桥式起重机参数：The Parameter of Crane 3 3. 安装场地规划 Layout of installation site 5 II. 施工组织及资源配置Construction Oraganization and Resource Allocation 6 III. 桥机设备运输及吊装Bridge Crane Equipment Transportation Lifting 11 1. 桥机设备吊装方案确定Bridge crane equipments lifting program confirmed 11 2. 桥机设备起重运输机械选型Bridge crane equipment hoisting transportation mechanism choose type 11 3. 桥机设备吊装机械选型 12 4. 桥机主要大件吊装 Bridge crane main large parts lifting 12 IV. 170T/10T、10T桥机安装方案170T/10T, 10T Bridge Crane Installation Program 21 1. 安装工艺流程简介Brief Introduction of Installation Technology Flow 21 2. 安装流程图 Installation flow chart 23 3. 桥机各主要部件的安装及组装Installation and assembly of each main part of bridge crane 23 4. 小车架组装 Assembly of small trolley frame 27 5. 主、副小车运行机构以及起升机构组装 Assembly of main, deputy small trolley running mechanism and hoisting mechanism 28 6. 小车安装要求：The requirements of small trolley installation: 28 7. 起升机构钢丝绳穿绕 Hoisting Mechanism Wire Rope Reeving 30 8. 保护措施 Protection Measurements 31 9. 桥机电气部分设备安装： Electrical Parts Equipment Installation of Bridge Crane 31 10. 质量控制点 Quality Control Point 37 施工概述 Brief 工程内容：Content of work 该项目包括二台厂房桥式起重机（含轨道、滑触线等）的运输、二次倒运、安装及协助调试等工作。一台为主桥机170T/10T/10T，另一台为副桥机170T/10T。 The project includes the transportation, secondary transportation, installation and commissioning assistance, etc work of two EOT bridge cranes (including rail and main lead gantry). One is master crane 170T/10T/10T; one is slave crane170T/10T. 桥式起重机参数：Technical Specification of Crane 本体尺寸 Size of the crane 桥机大车跨度： 18000 mm Carriage span: 18000 mm 桥机小车跨度：5300 mm Trolley span: 5300 mm 主梁外形尺寸：长×宽×高= Main beam dime