印尼棕榈壳粉碎机简介.docVIP

Sawdust crusher Structure and operating principle This machine is combination crusher, stop cutting machine, slice and crushing the first cutting into the crushing, by the hammer piece at high speed, and the wind screen send out material mouth, a become particles. Sawdust crusher instructions 1, switch on the power, to see whether it is right. 2, put in cutting tools, blade knife dish out planar 2-4 mm, and then lock down the bolt. Such as the discovery of pressure bolt thread is wear, should be replaced immediately, in order to prevent caustic slide the knife dish nut. 3, change the sword expansion degrees, must be stretched the length of the sword consistent. 4, by the sword length, particles of less than ideal, change of different diameter luo sieve 5, it is strictly prohibited to carry the stone, nail wood into machines, in case of a break in a sword and 6, check hammer piece of bolt, found loose, immediately tighten, hammer slice and bolt wear serious when, should be replaced. 7, sharpening Angle for the straight line 28-30 °, forbidden ground into raised face, raised face can lead to steel blade from or local jie steel. 8, often use machines should check whether the bearing grease lack. Should be 3-4 hours raises a butter, charging too much butter not easily. Sawdust crusher Method of use 1, this machine use, do not change the power and speed, Angle grinder, straight line kept the original 28-30 °. 2, change, grain, needs a new ROM, blade adjustment simultaneously, LuoKong minimum not less than 14 mm (diameter), the biggest not more than 20 mm (diameter), and the sword length 3-6 mm, the bottom of the knife knife plate and the gap is not more than 1 mm. 3, the machine can powder 3 cm in diameter-20 cm of the wood into granular. 4 The quality of incoming material feeding port the biggest diameter is 300 mm. If wood diameter feeding port more than the biggest diameter, can use the form a complete set