AEC-Q200 reliability test for magenetics.pptVIP

ENVIRONMENTAL TEST 2.Temperature cycling Standard JESD22 METHOD JA104 Equipment Fast variety temperature test chamber Testing method Temp: -40℃ to 125 ℃ ramp rate : 10 ℃/min Cycle rate :1 cycle per hour Soak time : 15min at temp extreme Test cycle: 1000 cycles Measurement Check appearance and electrical characteristic test prior to and after exposure, Measurement at 24+/-2 hours after test conclusion. ENVIRONMENTAL TEST 3.Thermal shock Standard MIL-STD -202 METHOD 107 Equipment Thermal shock test chamber (air to air) Testing condition Temp:-40 degree ℃ ~ 125degre ℃. Test cycle: 300 cycles. Transfer time :20s max. microscope Programmable temperature and humidity chamber Programmable temperature and humidity chamber Programmable temperature and humidity chamber Fast variety temperature test chamber Programmable temperature and humidity chamber Test equipment Inspect device construction, marking and workmanship 1000Hours at 105 ℃ 1000hours at 85 ℃ 85%RH, Unpowered t=24hours/cycle .note: step7a7b not required, unpowered 1000cycles (-40 ℃ to 125 ℃) 1000hours at rated operating temperature，unpowered Additional requirements MIL-STD -883 METHOD 2009 MIL-PRF-27 MIL-STD -202 METHOD 103 MIL-STD -202 METHOD 106 JESD22 methodJA-104 MIL-STD -202 METHOD 108 Standard External visual Operational life Biased moisture Moisture resistance Temperature cycling High temp storage Test TABLE OF METHODS REFERENCED MAGNETICS TABLE OF METHODS REFERENCED MAGNETICS Solder pot Vibration tester Half-sine generator Pull tester micrometer Test equipment Condition B no preheat of samples. note：single wave solder-procedure 2 for SMD and procedure 1 for leaded with solder within 1.5mm of device body 5g’s for 20 minutes, 12 cycles each of 3 orientations ， test from 10 to 2khz Figure 1 of method 213,condition C Add aqueous wash chemical ,OKEM clean or equivalent , don’t use banned solvents Test leaded device integrity Conditions: A(910g), B(1.13kg),E(1.45Kg-mm) Verify phy