耐高温150度铝粉漆参数.docVIP

Intended Uses 用途 用于温度最高达150℃的钢材设备表面涂装 Suited for equipments with the temperature up to 150℃ Product Information产品简介 一种浅色，反射性铝粉耐热漆 A light, reflective aluminium heat resistant finish. Two packages Application details 产品数据 Volume Solids 固体份 ≥40% Dry Flm Thickness干膜厚度 20-30microns 20-30微米 Theoretical Coverage 理论涂布率 11.5m2 /Kg , based on dry film thick 30um 11.5平方米/公斤,以30um 干膜厚计 Practical Coverage 实际涂布率 Allow appropriate loss 允许适量损耗 Storage and Handling 施工详述 Mix Radio 混合比 A:B 4 : 1 By weight 甲：乙 4：1 重量比 Method of Application 施工方法 Airless Spray 无空气喷涂 Suitable 适用 Brush or Roller 涂刷或辊涂 Recommended 推荐采用 Conventional Spray 传统喷涂 Recommended 推荐采用 Thinner 稀释剂 SC001 Cleaner 油漆设备清洗设备 SC001 Pot Life 使用期 Not limit 不限制 Storage 贮存期 One year 一年 Drying time 干燥时间 Substrate Temperature 底材温度 Touch Dry 表干 （min） Hard Dry 硬干 （h） Over coating Interval 涂覆时间 Min最短 Max 最长 35℃ 25℃ 15 30 12 24 0.5hours 小时 1hour 小时 Not limit 无限制 Storageand Handling 贮存与管理 Storage 贮存 Store in cool and dry conditions 贮存于阴凉干燥处 Pack size 包装规格 20kg in 20 liter container 20公斤装于20公升容器中 Flash Point 闪点 24℃ Specific Gravity 比重 1.15Kg/L 1.15公斤/公升 Specification and Surface preparation 技术要求及表面处理 Before applying it no primer ,the surface to be applied must be checked and treated according to the ISO standard, Remove the oil with solvent according to the SSPC-SP1 standard, Blast to Sa2.5 or rust-removed manually to St3, clean and dry. The surface may be applied with right heat-resistant primer, the primer surface must be clean and dry. 单独使用前所有待涂覆的表面根据 ISO标准进行评估和处理，如有油脂，应用溶剂清洗至 SSPC-SP1标准，喷砂清洁至 Sa2.5级或动力工具除锈至 St3级，去除灰尘和污物。 与合适的耐热底漆配合，底漆表面保持清洁干燥。 Safety Precautions 安全措施 This product should be used in painting area by perfessional operators. When painting , please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product. This product is a kind of solvent-based paint .Inorder