350节瘤处理意见.docVIP

Dear Mr. Zha Xiangguo, ?张向国： We are waiting for you and expecting at our site at the earliest. Meanwhile, we faced some difficulty in our Blast Furnace no.3. I like to explain in detail and in case you are not in a position to understand the problem kindly give a phone call. ?ESL 350高炉面临一些困难，以下是详细描述，并请给出解释： Last few days our furnace is not giving good production and it is in the range of 500-600 TPD. We took a shutdown and lowered the raw material level 9 metre below the stock level. After opening the top manhole, we observed the furnace inside through manhole. On investigation we found a large chunk of scaffolding material build up around 65% of peripheral area around lower stack zone. ?近期，350高炉 生产不是顺利，每天产量在500-600吨，我们采取了休风并把料线降到9米水平，低于探尺以下，打开人孔后观察到在炉身下部区域一个巨大的环形瘤（由原料组成）。大约占据炉身下部区域65%的范围； I request to get some ideas from Laiwu Steel Plant or other places to drop this scaffolding or to dissolve this scaffolding. Moreover, on details of furnace shell study, we found 3 layers of 4 nos. holes at different elevation of furnace stack accretion inspection hole .Kindly give us the idea about the purpose of these holes and how these can be utilized to remove the scaffolding. ?我希望从莱芜钢厂或者其他地方得到一些去除这个瘤的想法或者帮助解决这个问题，再有在炉身部位设计大探瘤孔3层4个/层;请说明这些探瘤孔的用途，如何用来去除 In addition to the above, kindly indicate the quantity of water to be maintained in different level of Cooloing Stave during shutdown of furnace for more than 12 hours. In case you have standard chart of reduction of water quantity with hours of shutdown, kindly forward us the same. ?另外：请提供高炉休风期超过12小时，炉体冷却水量的控制要求，按照中国国内的相关操作及规范。 Thanks Regards,谢谢 S?N Goswami Dear Mr Goswami: After check your E-mail I discussed with Laiwu Steel plant process technology engineer,we give below sggest for refrecec : 1.采用洗炉方法：Furnace washing operation : 1.1使用萤石洗炉，尽量保持萤石布在高炉靠近边缘区域；Use fluorite as washing dose ,keep the fluorite discharged inside the furnace edge area as possible . 高炉轻负荷炉料结构；炉温[Si]控制在1.3-1.5%左右；铁水大于1480℃；煤比控制在：0Kg/THMTL以下。炉渣