kek访问报告.pptVIP

Progress and Plan for Superconducting RF Cavity RF Group Progress in Last Year Transport two SC cavity modules and couplers from harbor to IHEP by air-suspended truck Leak check after transportation (instructed by Prof. Mitsunobu, MELCO send a Supervisor to check all of things) Evacuate niobium cavity cell and insulation vacuum vessel, high pressure rising up of helium vessel and nitrogen cooling channel. Do leak test for niobium cavity cell and insulation vacuum vessel. Prepare clean work environment Design and construct clean room of class 10’000 for cavity assembly in RF hall of building six. Design and construct clean booth of class 100 for HOM damper assembly. Design and construct clean cap of class 100 for coupler assembly. Progress … con’t (1) Assembly of beam taper, RF bellow, gate valve and ion pump, as well as vacuum gauge and mass analyzer together. It include two SBP and two LBP module Ultrasonic washing, ultrapure water rinsing for each beam taper. Connected all components on to the beam taper. Leak test and high temperature baking. HOM damper baking (Prof. Furuya, a S.V from MELCO) Ferrite surface check. (There exist a remarkable cracking on the ferrite of the SBP2 HOM damper, KEK borrowed their spare one to us via Melco) Connect HOM damper on the beam taper. Baked four HOM damper by heated cycle water around 45 Celsius degree for two months. Progress … con’t (2) Assembly of the No.2 SCC module (Prof. Mitsunobu and Furuya, a S.V from MELCO) Slow leak cavity, coupler and HOM damper in sequence. Mount coupler on the cavity module. Connect SBP and LBP HOM damper on to the both side of cavity module separately. Evacuate whole module and do leak test. Ion pump baking. Move the No.2 SCC module to the horizontal test room Preparation for final performance test (Furuya, a S.V from MELCO) Locate and adjust module to the right site in test room. High power waveguide connection. Connect cryogenic transfer line and safety valve, some modification will be done.