STC11L02E 单片机和NRF24L01无线模块程序.docVIP

STC11L02E 单片机和NRF24L01无线模块程序 /**************************************************/ //单片机 STC11L02E //zzq #include reg51.h #include intrins.h #define uchar unsigned char // Define interface to nRF24L01 // Define SPI pins sbit CE = P3^1; // Chip Enable pin signal (output) sbit CSN = P3^3; // Slave Select pin, (output to CSN, nRF24L01) sbit SCK = P3^4; // Master Out, Slave In pin (output) sbit MOSI = P3^5; // Serial Clock pin, (output) sbit MISO = P3^7; // Master In, Slave Out pin (input) sbit IRQ = P3^2; // Interrupt signal, from nRF24L01 (input) // SPI(nRF24L01) commands #define READ_REG 0x00 // Define read command to register #define WRITE_REG 0x20 // Define write command to register #define RD_RX_PLOAD 0x61 // Define RX payload register address #define WR_TX_PLOAD 0xA0 // Define TX payload register address #define FLUSH_TX 0xE1 // Define flush TX register command #define FLUSH_RX 0xE2 // Define flush RX register command #define REUSE_TX_PL 0xE3 // Define reuse TX payload register command #define NOP 0xFF // Define No Operation, might be used to read status register // SPI(nRF24L01) registers(addresses) #define CONFIG 0x00 // Config register address #define EN_AA 0x01 // Enable Auto Acknowledgment register address #define EN_RXADDR 0x02 // Enabled RX addresses register address #define SETUP_AW 0x03 // Setup address width register address #define SETUP_RETR 0x04 // Setup Auto. Retrans register address #define RF_CH 0x05 // RF channel register address #define RF_SETUP 0x06 // RF setup register address #define STATUS 0x07 // Status register address #define OBSERVE_TX 0x08 // Observe TX register address #define CD 0x09 // Carrier Detect register address #define RX_ADDR_P0 0x0A // RX address pipe0 register address #define RX_ADDR_P1 0x0B // RX address pipe1 register address #define RX_ADDR_P2 0x0C // RX address pipe2 register address #define RX_ADDR_P3 0x0D // RX