机电工程论文模板.docVIP

北京理工大学继续教育暨现代远程教育学院 毕业设计(论文) 类　别： 远程—专升本 专 业： 机电工程 班 级： 山西教学站 (教学站) 姓 名： 孙 智 毕业设计题目： 太钢三高炉分配器改造 指导教师姓名： 荣 辉  摘要系统的煤粉高炉长时间喷吹煤粉、喷制系统定修或日修后，会因制粉系统的振动筛破损、煤中垃圾多、检修后管道落入异物、枪头结焦等原因，致使与主枪体有一定角度的枪头堵塞异物，普通的排堵方法无法去除异物，一般就是将该喷枪停喷。由此将给高炉冶炼带来相当多的负面影响：短期来讲，它将严重影响喷煤量，高炉冶炼成本上升；长期来讲，喷煤量在高炉圆周方向的不均压将导致煤气流分布不均和下料的偏行，造成设备的损失、炉温的波动，甚至会造成高炉炉况失常，给生产带来巨大的损失为了进一步降低炼铁成本，进行设备改造改造后提高了高炉喷煤比，稳定了设备运行，减少了堵塞，达到了降低炼铁生产成本的目的Abstract Four blast furnace operation as TISCO, the hour can be transported to the three-70t coal furnace, three blast furnace pulverized coal injection system has surplus capacity, but dusting the uneven distribution of the pipeline is still limited by the ratio of blast furnace coal increased. Three long blast furnace pulverized coal injection, spray system repair system is scheduled to repair or day after, because of damage shaker mill system, waste coal and more into foreign pipelines after maintenance, tips coke, that lead to and main gun has a certain angle plug tips foreign body, the ordinary methods can not remove the foreign body Paidu general is the gun Minting. Blast furnace which will bring a lot of negative effects: short term, it will seriously affect the coal rate, blast furnace smelting costs; the long term, the amount of pulverized coal injection in blast furnace circumference direction of gas flow will result in uneven pressure and cutting the uneven distribution of the partial line, resulting in loss of equipment, temperature fluctuations, or even result in abnormal blast furnace conditions, to produce huge losses, in order to further reduce the cost of iron, the three pulverized coal injection system a powder dispenser equipment research and transformation. Keywords: distributor, Research and reform，coal injection ratio 目 录 摘 要 2 Abstract 3 目 录 4 前 言 6 1 太钢三高炉喷吹系统结构与缺陷 7 1.1太钢三高炉喷吹系统结构 7 1.2造成太钢三高炉喷吹系统缺陷的原因分析 8 1.3太钢三高炉喷吹系统缺陷改造 8 2 分配器的改造分析 11 2.1喷粉系统的能力分析 11 2.2盘式分配器和瓶式分配器的主要区别 13 2.2.1问题的提出 13 2.2.2主要原因分析