ocss设置1-3.docVIP

Group 1: General OCSS常规设置 No. Symbol Initial初始 Setting设置 Purpose and Range 1-1 RCB-NO 1 Car Identifier 轿厢标识 1 to 8 = car A to H Car identifier in group.在群控中的轿厢标识（序号） 1-2 EN-CON 0 Enable Contract Software合同软件授权 0 = disable contract software禁止 1 = enable contract software激活 Determines if the contract software, contained in the contract EPROM chips, should be executed. 1-3 EN-EMO 0 Enable Overlay Controller Functionality（启用覆盖控制柜功能性） 0 = disable overlay controller functionality 1 = enable overlay controller functionality This parameter should be enabled when the OCSS resides on an EMO or TEMO. Once a full MOD controller is in place; for example, an E411M or E311M controller, this parameter should be disabled.（到OCSS处于EMO或者TEMO时，应将此参数置一。一个完整的MOD控制柜使用时，比如，一个E411M或者E311M的控制柜时，此参数应该被取消） 1-4 SVT-PO 1 Service Tool Position Offset服务器位置偏移 0 = service tool positions start at landing 0（服务器位置从楼层0开始） 1 = service tool positions start at landing 1（从楼层1开始） Specifies whether positions are displayed on the Service Tool starting at landing 0 or landing 1.（指定服务器上的位置显示是以1还是以0开始） 1-5 #RINGS 1 Number Of Rings Used For Communication 1 = Use one ring for most communication to save CPU使用一个环形通讯 2 = Use two rings for all communication使用二个环形通讯 This variable specifies the number of rings to be used by the OCSS to communicate with each other.（此变量指定OCSS用来彼此通讯的环数） 1-6 R-BAUD 192 Ring Communications Baud Rate环行通讯比特率 96 = 9600 baud 192 = 19200 baud Defines baud rate used for ring communications. Note that all the cars in the group must have the same ring communications baud rate. Also note that the controller power must be cycled for the change to take affect.（定义环行通讯的比特率。注意：群组中所有的轿厢必须拥有同样的比特率。同时，要使改变生效，控制柜电源必须生效） 1-7 EMS-O PL******EMS Options （EMS选项） P bit = 0: disable EMS parameter passing（禁止EMS参数通过） P bit = 1: enable EMS parameter passing（使EMS参数通过） L bit = 0: transmit OCSS load states using ICD 4.1 or lower（用ICD4.1或者更低的版本传输OCSS负载状态） L bit = 1: transmit OCSS load